8路数据循环采集，用MAX7219驱动数码管显示转换后的值以及通道号...

说明： 1. DL1MS: 延时1ms 子程序, DL01MS : 延时0.1ms 子程序 2. MOV R0,#80H 红外接收的数据的地址 80H~8DH 3. SHOW_RFCODE 在LCD上显示红外接收的数据(演示用） 4. 在中断中建立红外接收数据标记，在主程序中调用RF_JS-Note: 1. DL1MS: Subroutine 1ms delay, DL01MS: Subroutine 0.1ms latency 2. MOV R0,# 80H infrared receiver data address 80H ~ 8DH3. SHOW_RFCODE in LCD display infrared receiver of the data ( demonstration using) 4. in the interruption of infrared receiver to create a data marker, in the main program call RF_JS

此文件包含用visual c++编译的程序代码，绝对可用CH06.rar-This file contains the use of visual c++ compiled code, can be used absolutely CH06.rar

sd 的spi模式详细的中文资料，一位好心人翻译的-sd of the spi mode in detail the information the Chinese, a translation of well-wishers

IIC读写的例子，符合标准协议的写法！--Examples of IIC standard-compilant read/write operation.

海， 我已添加变送器 CC25xx 例程进行测试。

基于Haar特征及Adaboost算法的人脸检测代码。opencv已有的分类器，注意更改分类器路径。检测速度有点慢，对于人脸姿势要求较高

freeRTOS 移植到 STM32F1xx 与 STM32F10x_StdPeriph_Driver 和V7.6.0 freeRTOS — — Mikrocontroller — — Konfiguration — — 选定单片机具有定义文件"stm32f10x.h"或在 编译器选项 （预处理器符

此程序为串口芯片tl16c750在uClinux + s3c44b0环境下的驱动程序.tl16c750R FIFO设置为64BYTES, 除此之外,此程序还能缓存20条已经收到的串口数据.即存储数据量为20*64=1280BYTES的串口数据,而不用担心未及时读串口时发生数据的丢失现象.此外,附此驱动的测试程序,以及编译后的映像文件.-procedure for the serial port chip tl16c750 uClinux s3c44b0 environment of flooding action procedures. tl16c750R FIFO set to 64 BYTES, in addition, This procedure can cache 20 has been received by the serial data. that the data storage capacity of 20* 64 = 1280BYT ES Serial data, and do not have to worry about failure occurred when reading serial data loss phenomenon. In addition, Report this driver testing procedures, and compile the map file.

使用TRULY的液晶显示模块320*240-use the LCD module 320* 240

基于CPLD的FSK信号发生器的设计.PDF-based CPLD FSK signal generator design. PDF