bill-recognition

C8051F020 东软电力载波集中器命令处理程序-C8051F020 Neusoft Power Line Carrier for order processing

parted-3.0.tar,使用GPT分区，支持超过4T的硬盘分区

应用背景逆变器采用正弦PWM生成dsPIC30F6014A关键技术纯正弦波20kHz调制给LC滤波的完美的波浪

程序说明: 本次实验利用开发板上面的数码管实现一个十进制计数器的功能。 计数范围0000-9999，可循环计数。 目录说明: 工程在project文件夹里面; 源文件和管脚分配在 tl文件夹里面; 下载文件在download文件夹里面,.mcs为PROM模式下载文件,.bit为JTAG调试下载文件。

24CXX全系列EEPROM底层读写函数，自己写的，IIC接口函数自己根据具体方法可以模拟或硬件实现-qi bottom of the whole series EEPROM read and write functions, wrote, IIC interface function in accordance with their own specific methods can be simulated or hardware

总的来说，在uClinux上的开发和标准Linux还是很类似的。通常可以按照下面的步骤去设计和调试： 建立基于以太网的开发环境； 如果所设计的程序和硬件的关联不大，那么一定要在标准Linux上先编译和调试通过。灵活地使用gcc和gdb将大大节省时间； 将x86上的GCC编译好的应用程序用交叉编译工具来编译；如果编译时发现错误，那么很可能存在以下问题： 交叉编译器或库文件的路径不正确；最彻底的解决办法是重新装一次编译器； 遇到库不支持的函数；此时需要自己把函数的实现做成另外一个库供应用程序使用。如果是uClinux本身不支持的调用，那么就需要改写代码了。-Overall, the uClinux on the development and standard Linux is still very similar. Usually can use the following steps to design and debug : Ethernet-based development environment; If the design of the procedure and not linked to the hardware, then it must be the first standard Linux compiler and debugging through. Flexibility in the use of gdb and gcc will greatly save time; X86 will be on the GCC-compiled application with cross-compiler tool to compile; If you compile time error is found, it was very likely that the following issues : cross-compilers or libraries are not the correct path; The most radical solution is a re-installed time compiler; encountered does not support functions; At this time the need to

正弦信号发生器[2005年电子大赛一等奖].files-sinusoidal signal generator [e-Competition in 2005 won first prize]. Files

嵌入式系统的图形用户界面设计研究 无忧电子开发网-技术文章-Embedded System Design of a graphical user interface to worry about electronic Development Network- Technical article

看门狗自动采集数据-watchdog automatic data collection

dip-switch -microblaze-dip-switch-microblaze