将本站的UCOSFORAVR128V276版本升级到了280版，修正原来的中断定义错误，并仿真调试已通过。...

说明：  STM32F103ZET+LCD 7 INCI+TOUCH

ucos-ii参考手册-ucos-ii reference manual

针对STM32F103的UCOS移植，支持RealView MAK及IAR开发环境-UCOS for the STM32F103 transplantation, support for RealView MAK and IAR development environment

这是我针对LPC2000系列的一个串口发送接收的程序，对学习NXP系列的朋友是一个很好的例程，特别是串口部分，其编程风格也不错-This is my LPC2000 series against a serial sent to receive the procedure, NXP learning series is a very good friend of routines, especially the serial part of good programming style

一段基于ucos系统的程序，运行在S3C2440上，方便测试(A UCOS system based on the program, run in S3C2440, easily test)

uc/cosII for m68k 内核-uc/cosII for m68k kernel

网上有很多关于ucos移植到c51的资料，但基本都没有调试文档，让很多有心去了解ucos的人走不少弯路，现在附上本人在STC89C516RD+成功运行的版本，其实主要的移植部分都没有改动，主要是说说自己的心得，另附上ucos源代码注释文档以及keil C51的详细设置文档(There are many online about the ucos transplantation information to c51, but basically no debugging document, so a lot of interest in understanding ucos take many detours, now attach I successfully run in STC89C516RD+, version, in fact, a major part of the transplant are not changed mainly talk about my own experience, attached on ucos source code comment documentation, and detailed settings document keil C51)

基于ST公司低功耗产品STM32F103ZET6的红牛ARM开发板出场程序，uCOS+uCGUI(FSMC)28。(Based on ST' s low-power products STM32F103ZET6 appearance of Red Bull ARM development board procedures, uCOS+ uCGUI (FSMC) 28.)

这是个介绍初入UCOS的程序员门，希望对你们有帮助。-This is a introduction uCOS programmers entering the door, hoping for your help.

51单片机UCOS系统移植，包括全部源码，以及自己写的部分代码，编译通过(The 51 single-chip UCOS system transplantation, to including the the the all source code, as well as to write their own of the part of the code, the compiler through)