C #代码访问文档图标的例子

基于51单片机的颜色传感器的 调试程序 用于机器人巡线的基础程序(The color sensor based on 51 single-chip debugger basis for the transmission line robot program )

FriendlyARM English User Manual Chapter 4.4 Compile and Program uCos2

hs108单片机控制两个MC44BS373CA实现载频为30MHz和50MHz的I2C通信(hs108 MCU control two MC44BS373CA achieve carrier frequency of 30MHz and 50MHz of I2C communication )

Code contains basic math functions.Written in codeblocks as c code.

【实例简介】 利用pid调节pwm输出，使轮速稳定

说明：  设计一个正弦信号发生器，使用凌阳公司的16位单片机SPCE061A作为中央控制器，结合DDS芯片AD9850，产生0～15MHz频率可调的正弦信号,正弦信号频率设定值可断电保存；使用宽频放大技术，在50Ω负载电阻上使1K～10MHz范围内的正弦信号输出电压幅度VP-P=6V±1V；产生载波频率可设定的FM和AM信号；调制信号为1KHz的正弦波，调制信号的产生采用DDS技术，由CPLD和Flash ROM加上DAC进行直接数字合成；二进制基带序列码由CPLD产生，在100KHz固定载波频率下进行数字键控，产生ASK，PSK信号。(Design of a sinusoidal signal generator, the use of Sunplus 16-bit MCU SPCE061A as the central controller, combined with DDS chip AD9850, have adjustable frequencies 0 ~ 15MHz sinusoidal signal, sinusoidal signal frequency settings can be stored power using broadband amplification, in a 50Ω load resistor to 1K ~ 10MHz sinusoidal signal within the output voltage amplitude VP-P = 6V ± 1V generating the carrier frequency of the FM and AM can be set signal 1KHz sine wave modulation signal, modulated signal generation using DDS technology, coupled by the CPLD and Flash ROM DAC for direct digital synthesis binary baseband sequence code generated by the CPLD in a fixed carrier frequency 100KHz digital keying, resulting in ASK, PSK signals.)

系统平时处于循环接收检测状态，当有按键动作后发送数据 ，对方收到数据后LED闪烁， 任何一方可以发数据也可以收数据。 1． 当检测到按键动作后发送数据，自身LED闪烁 2． 当收到数据后LED闪烁 (Usually in the loop receiver detect state data, send keystrokes LED flashes after receipt of this data, either party can send data can also receive data. 1. When sending data detected keystrokes own LED flashes. LED flashes when data is received)

IIR数字滤波器的设计 上学的时候一直不知道如何用C语言来编写IIR滤波器，终于找到了，上传给大家 希望能帮到大家。(IIR digital filter design when the school did not know how to use C language to write IIR filters, and finally found it, upload to hope to help you.)

STM32F103C8   的 FLASH保存数据例程的代码，希望对需要的人有用

这个程序是一个计算器的例子，在一个可视化的工作室里，网络的形式