三菱FX系列通讯程序,可实现PC机与PLC的通讯,在PC机上监控PLC运行状态...

TDD LTE 系统中的RACH的 matlab 程序代码。欢迎下载。谢谢你的支持。

1)生成2KHz和8KHz的混合信号，使该信号通过上述滤波器，观察滤波前后的波形变化和频谱分布情况。 2) 在改信号中加入高斯白噪声，观察滤波前后的波形变化和频谱分布情况3) 将上述滤波器改为中心频率为100KHz的带通滤波器，信号源为带外的90KHz和带内的100KHz的混合正弦信号，。 4) 用M文件实现上述低通滤波器。 -1) 2KHz and 8KHz to generate the mixed-signal, so that the signal through the above-mentioned filter, filter before and after observation of the waveform and spectrum distribution of the changes. 2) add to the signal in white Gaussian noise was observed before and after filtering and spectral waveform changes in the distribution of 3) will be replaced by the above-mentioned filter center frequency of 100KHz band pass filter, the signal source for the band and the band of 90KHz 100KHz Sine of the mixed signals. 4) achieve the above-mentioned documents with M low-pass filter.

linetd是一个压缩TCP高级服务器。所有的设置值都受控于命令行。与tcp服务器或sinetd类似。-linetd compression is a senior TCP server. All settings are controlled value on the command line. With sinetd tcp servers or similar.

在通信的下行链路，解PBCH的最后一步会用到CRC的校验。本程序实现了这一功能，并且能跑通，有注释。

A detection software

BOrgTec GPSRS232 ActiveX Control提供如下特性：分析NMEA串，也就是说包含在NMEA序列里的数据将被提取出来。数据由ActiveX事件提供。NMEA序列从与PC串口连接的GPS接受器中获得。可以配置串口的参数，以与多种GPS接受器进行通讯。配置ActiveX Control显示数据的字体颜色和计量单位。这些特性使你在应用中加入GPS功能变得简单。适用语言：D5-BOrgTec GPSRS232 ActiveX Control provides the following features: Analysis of NMEA string, that is included in the sequence in the NMEA data will be extracted. Data provided by the ActiveX events. NMEA sequence from the PC serial port to connect with the GPS receiver gain. Serial port parameters can be configured to a variety of GPS receivers and communication. ActiveX Control to configure the font color display data and units of measurement. These features allow you to add in the application of GPS functionality simple. The application of the language: D5

应用背景该代码用于在线多参数水质监测，测量DO，PH，EC，CHLA和TUR的参数及其温度数值，该代码已测试通过，可以使用，采用RS485串口通信，并运用modbus通信协议。关键技术本项目采用了通过STM32控制模拟开关，渐而控制五个传感器的导通情况，用来控制传感器发送采集到的数据，并将采集到的数据打包起来，发送发给上位机。

利用CC1000通信的仿真程序.这是适用于无线传感器网络Mica2平台的程序.-use CC1000 communication simulation program. This is applicable to the wireless sensor network platform Mica2 procedures.

AN2120, Connecting an M68HC08 Family Microcontroller to an Internet Service Provider (ISP) Using the Point-to-Point Protocol (PPP).

VB.net版串口控制串口控制activeport安装档和钥匙枪