GPS入门的经典图书《GPS基本原理及其matlab仿真》的PPT课件

这是GPS接收机仿真的程序， GPS数据由给定文件来模拟，对于GPS爱好者很实用。-This is the GPS receiver simulation procedures, GPS data given by the paper to simulate, for GPS enthusiasts practical.

GPS主系统是居心叵测的老美发射运行的卫星系统，包含了27颗能持续发送地理位置海拔高度的卫星，24个正常使用，3个备用，这些卫星平均分布运行在六个轨道上。一般来说，在地面-GPS is the main system is very much ill-old US-run satellite launch system, contains 27 to continue to send location altitude satellites, 24 of normal use, three back-up, the average distribution of these satellites orbit in six runs. Generally speaking, on the ground

一个GPS网WGS_84平差坐标向地方独立坐标的转换文档，比较全-A GPS network adjustment WGS_84 independent coordinates to local coordinates of the conversion document, compare the whole

可以接收NMEA-0183格式的GPS数据自动化搜索本枸的GPS接口-can receive NMEA- 0183 format of the GPS data automation of the search interface GPS Citrus medica

GPS-modem commands SIM508Z (en)_SIM508_GPS_COMMAND_V1.01

GPS信号的基带处理在IEEE发表的文章有关信号捕获和跟踪-GPS baseband signal of the article published in the IEEE capture and tracking of the signal

非常实用的工具，可以用Matlab来进行射频上船用的转换以及分析。（例如可以将S矩阵转化成Z矩阵，放大器稳定性分析……）-Very useful tool, you can use Matlab to carry out on the marine radio frequency conversion, as well as analysis. (Such as the S matrix can be transformed into Z matrix, amplifier stability analysis ... ...)

该程序是信号的多普勒现象，通过设置不同的参数，可得到不同的现象，具有一定的参考价值。-that the procedure was the Doppler signal, by setting different parameters, will be different, has some reference value.

    利用GPS模块模拟公交车到站站台显示和播报，自动识别不同站点的坐标

基于arduino的GPS地图导航系统 SPI接口。采用Atmega 328为主控芯片 需要采用滤波算法过滤 串口速率与GPS模块要设置一致，接线方式如下： //TFT SDA -> UNO 11 //TFT SCK -> UNO 13 #define TFT_CS 10 // Chip select line for TFT display #define TFT_A0 9 // Data/command line for TFT #define TFT_RST 8 // Reset line for TFT (or connect to +5V) #define TFT_LED A0 #define SD_CS 4 // Chip select line for SD card //SD MISO -> UNO 12 //SD SCK -> UNO 13 //SD MOSI -> UNO 11 //GPS tx - UNO rx //GPS rx - UNO tx #define BTNZOOMIN 2 #define BTNZOOMOUT 3