I2S总线规范

按键驱动程序示例, 按键驱动程序的描述，基于up netarm2410 s 开发平台-Key driver sample

这是费浙平写的《ARM 体系结构及基于ARM 的嵌入式开发》非常不错。-Zhejiang-written "ARM Architecture and ARM-based embedded development" very good.

应用背景本代码可以用于嵌入式图形界面设计、工业控制等。用户可以将其修改或者自行设计将其投入到自己的应用中。（压缩包中附带硬件资料，用户可以参考）关键技术本测试代码采用了正点原子的4.3寸电容屏，本人将其原先的查询方式获取电容屏的改为中断方式获取用户输入，查询的效率不仅低，而且占用CPU的资源，所以本人通过查询数据手册，将其修改为中断方式获取屏幕坐标。并在此基础上移植了STemwin嵌入式GUI，用户可以将其修改或者自行设计将其投入到自己的应用中。（压缩包中附带硬件资料，用户可以参考）

这是利用ARM子公司KEIL的开发环境，其中用到的语言为C以及VISUAL C++，编写的是闪亮的程序。-This is the use of ARM subsidiary KEIL development environment, in which the language used for C and VISUAL C++, The preparation of the flashing procedure.

STM3210B-EVAL_Demo -STM3210B-EVAL_Demo

嵌入式系统ARM论文-papers ARM Embedded System

nec 78K0 样例对程序初始化电表样-nec 78K0 sample initialization procedure right-meter

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

这个是VB写PC与单片机通信程序要用的控件（Mscomm32）-This is a PC to write VB program to use with single-chip control communications (Mscomm32)

LPCEB2000-S单片机PWM-DAC控制程序，希望对大家有帮助-LPCEB2000-S single-chip PWM-DAC control procedures, and they hope to help everyone