ucos2.52源码带详细的USOS的编写中文教程。是学习研究的好资料。...

ucgui3.90原吗,有memdev部分,支持彩旦-ucgui3.90 the original right, has memdev part, support彩旦

说明：  LPC1788 UCOS-II应用示例(LPC1788 and ucos-ii application instance)

写者优先问题。操作限制：1）写-写互斥；2）读-写互斥；3）读-读允许；写者优先的附加限制：如果一个读者申请进行读操作时已有另一写者在等待访问共享资源，则该读者必须等到没有写者处于等待状态后才能开始读操作。-wrote priority issues. Operating restrictions : a) write-write contradict; 2) read-write mutually exclusive; 3) Reading-Reading allowed; Write priority of the additional restrictions : If an application for readers read operation has already been written in another waiting for access to a shared resource, the reader must wait until the person was not waiting for the after the state can begin to read operation.

uC/OS-II 源码公开的嵌入式实时多任务操作系统内核-uC/OS-II open-source embedded real-time multi-tasking operating system kernel

完成在S3C2410处理器上移植μC/OS-II内核，然后实现以下多任务： a) 控制实验箱核心板上4盏LED灯轮流亮灭； b) 将LED1连接到ARM9-2410EP增强型实验箱扩展口的DA OUT端口，通过实验箱上的键盘（比如“↑”、“↓”键）控制LED1亮暗变化，同时在超级终端显示该控制值； c) 将LED2连接到扩展口的I/O输出口，通过超级终端按键控制LED2亮灭，即按一下PC的超级终端某个键（比如回车键）LED2灭，再按LED2亮，反复循环。 -Completed the processor S3C2410 transplant μC/OS-II kernel, and then multi-task to achieve the following: a) control experiment box core board 4 bright LED lights out rotation b) will LED1 connected to the ARM9-2410EP enhanced experimental me expansion of the mouth of DA OUT port, through the experimental box on your keyboard (such as

ucos 中文手册,非常完善的 ucos 的源码注解。-ucos English manual, a very sound ucos source notes.

用HFSS仿真一个19G一分二功分器,S11，S21都良好(HFSS simulation of a 19G splitters, S11, S21 are good)

一个AT91SAM7X256 PIO中断控制实验，硬件环境为at91sam7x-ek开发板，开发环境为iar。-AT91SAM7X256 PIO interrupt a control experiment, the hardware environment at91sam7x-ek development board, development environment for iar.

说明：  STM32F103ZET+LCD 7 INCI+TOUCH

最初学习单片机的时候，由于条件，没有硬件，就只好用Proteus仿真，其实效果蛮不错的。到后来的高版本，直接可以支持ARM。相当不错的工具。此源码是其对uCOS在ARM上运行的仿真。-MCU when the initial study, due to conditions, not hardware, they can use Proteus simulation, in fact, quite a good effect. Later versions of the high direct support ARM. Pretty good tool. This source is its uCOS running in ARM emulation.