在ADI BF533上的G729编解码程序，内含两个测试向量，不过代码没有进行太多优化...

Welcome to the software files for the ADS8361 to TMS320F2812! There are two project files in each of the folders McBSP, SPI and Both. Mode II and IV are explored using the McBSP port alone, as well as the SPI port. These projects are located in the SPI and McBSP folders. Modes I and III are explored using both McBSP and SPI. In Mode I, the M0 and M1 pins are controlled by use of the jumper on the evaluation module. A0 is controlled by the DX pin of the McBSP port. In Mode III, the A0, M0 and M1 pins are controlled via GPIO functions of PortF. The "SRC", "CMD" and "INCLUDE" files in the archive are from "C28x Peripheral Examples in C" (document # SPRC097). If you have questions about this or other Data Converter products, feel free to e-mail us at: -Welcome to the software files for the ADS8361 to TMS320F2812! There are two project files in each of the folders McBSP, SPI and Both. Mode II and IV are explored using the McBSP port alone, as well as the SPI port. Th

在DSP开发板上调试通过的XF引脚测试程序，可以使发光二极管交替闪烁-in DSP development board debugging XF pin through the test procedure can alternately blinking LED

BLACKFIN BF533 的启动初试化程序-BLACKFIN BF533 initial start-up procedure

用CCS编的FIR滤波器，滤波系数用matlab计算-FIR filter。

TMS320DM6446平台下，使用TVP5150进行视频采集，使用DAC模拟输出的LOOPBACK测试的例程，在CCS下使用。简单易懂，很适合硬件调试人员硬件测试。-TMS320DM6446 platform, the use of TVP5150 video collection, the use of DAC analog output of the LOOPBACK test routines, in the use of CCS. Easy-to-read, it is suitable for hardware debugging hardware testing personnel.

基于DSP2812的spwm程序 EVA下面的通用定时器T1工作于连续增/减计数模式，产生三角载波，载波频率为3000Hz，载波比N=60，因此调制波形正弦波的频率为50Hz。本实验中，调制度为  0.8。 预存A相和B相的正弦值列表，C相的可以根据A相和B相的值计算出来

德州儀器 DSP DSP280x 之 cpu time setup 程式,已經在標準板中測試過!運作正常!!! 

本程序是基于TMS320F28335的SCI通信。本程序是利用F28335自身的SCI模块，通过配置SCI的寄存器，来设置波特率等，来实现F28335与PC机的通信。

TMS320LF2407 sci language code

这是DSP的视频教学软件，很适合初学者使用，简单易懂-This is the video teaching DSP software is well-suited to beginners and easily understood