4x4矩阵键盘电子琴把“单片机系统”区域中的P1.0 端口用导线连接到“音频放大模块”区域中的SPK IN 端口上； （2． 把“单片机系统“区域中的P3....

用C语言编写的，用于读取FM1608存储芯片上的数据，并显示的数码管上。-With the C language, the FM1608 is used to read data on memory chips and displays digital pipe.

51单片机浮点数存放到EEPROM中的程序范例-51 microcontroller to float stored in the EEPROM process model

宏芯 t103程序 能解码VGA CVBS S_VIDEO的视频解码，程序的开发环境是stc89c58rd+ 在keil c下已经编译通过-T103 Terawins procedures can decode VGA CVBS S_VIDEO video decoder, the program development environment is stc89c58rd+ In keil c have been compiled through

用来显示LCM103的单片机程序。非常好的例子，里面有很好的编程习惯。-used to show the SCM process. Very good examples, they have a good programming practice.

ADE7758的相关程序，包括对ADE7758的读写，以及校准程序-ADE7758 related procedures, including reading and writing on the ADE7758, and the calibration procedure

海泰克触摸屏编程软件ADP 6.0 的使用手册，有了它编程就很简单了。-海泰克touch-screen programming software ADP 6.0 user

AT89S51中文资料 全面介绍AT89S51的引脚及其功能-AT89S51 introduce a comprehensive English information on the pin and its function AT89S51

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

PHILIPS LPC2000 系列ARM7 微处理器 CAN 控制器驱动程序的编写与开发-PHILIPS LPC2000

Elan eKTP8733N单片机开发程序，用于驱动PWM接口。在Elan 公司开发环境中使用。-Elan eKTP8733N single-chip development process, used to drive PWM interface. Elan has developed in the environment.