读写1990A并模拟I2C存储EEPROM

44b0x bootloader

微软提供的Flash驱动程序-Microsoft"s Flash Driver

RTOS -REWORKS ReWorks里一个有关任务的例子-RTOS-REWORKSReWorks in an example of mission

嵌入式开发板连接程序源码，用于linux环境下连接开发板，调试程序-Embedded development board linker source code for the linux environment to connect a development board, a debugger

看门狗X25045控制子程序-watchdog X25045 control subroutine

cy7c68013 gpif波形图源代码 -cy7c68013 gpif waveform source code

AT91RM9200的USB host和USB device的代码ADS1.2. USB-Device测试程序: 因为程序运行在SDRAM中，所以要先初始化SDRAM（可用basic boot程序初始，之后不能复位或断电），再运行此程序，程序运行后连接USB端口，计算机会提示检测到新硬件，安装硬件驱动程序atmusb6119.inf 后计算机会把USB端口虚拟为一个串行的端口使用-AT91RM9200 the USB host and USB device code ADS1.2.USB-Device test procedure: Because the procedure is running in SDRAM, and so we have to initialize SDRAM (available for the initial basic boot procedure, followed by Can not reset or power off), then Run this program, the program to run after connecting USB port, the computer will be prompted to detect the new hardware, installing hardware drivers after the computer will atmusb6119.inf virtual USB port to a serial port to use

在大型通信系统（机架插板式）中多块单板通过TDM总线，利用HDLC协议实现内部通讯的源码-in large communication system (Plug-rack), plus veneer through TDM bus, HDLC protocol using internal communications FOSS

基于单片机AT89S52的LCD液晶显示程序-Based on MCU AT89S52 the LCD liquid crystal display procedures

微芯片 PIC 16F676 的 Capsense 3 按钮代码。编译与 ccs c 语言编译器。它的完整的编译的项目。