GPIO（通用输入输出）为TI的TMS320F2812 DSP的例子源代码

源程序是在VisualDSP环境下开发出来的，目标处理器是4片AD公司的TS1O1 DSP。IDE_FAT32用来在硬盘上创建FAT32文件系统；2）i2c_test编写IIC总线；3）codec_a_in_pal_cf_frame是加载到FLASH的程序，板子在脱离PC自动上电时会把PAL制的图像直接存到CF卡里，CF卡的文件系统是FAT16；4）codec_a_in_pal_buf_boottest是可加载的DSP图像直通程序；5）ADSP-TS101prog_driver是flash的驱动程序。-source of the VisualDSP environment developed, targeted four processor is the company"s AD TS1O1 DSP. IDE_FAT32 used in the drive to create FAT32 file system; 2) to prepare i2c_test IIC bus; 3) codec_a_in_pal_cf_frame FLASH is loading procedures, the board automatically from the PC on when power will be the PAL system images directly to CF card, the CF card is the FAT16 file system; 4) can be loaded codec_a_in_pal_buf_boottest DSP image through procedures; 5) ADSP-TS101prog_driver flash is the driver.

DSP编程的一个很好的实验程序，可以下载-a good experimental procedure, can be downloaded

dsp5402，mcbsp,DMA,中断传输，本人一条通-dsp 5402 mcbsp, DMA, interrupt transfer, I am a pass

基于矢量控制的永磁同步交流伺服电机控制系统 可以用的源程序-Based on vector control of permanent magnet synchronous AC servo motor control system can use the source code

适合用于2812的GPIO，能灵活的运用到各种系统中，并能充分的发挥2812的功能-Suitable for use in 2812 of the GPIO, the use of flexibility to a variety of systems and can be brought into full play the function of 2812

ADI公司TIGERSHARC的访问SDRAM的程序-ADI TigerSHARC visit SDRAM procedures

very helpful sources about dsp

一些TI的DSP2047上的我写的程序，供大家参考，还请大家帮忙改正错误．-some of the DSP2047 I wrote the procedure, for your reference, please help to correct the mistake.

DSP数字信号处理器的ADD32程序，32位加法器设计-DSP digital signal processor ADD32 procedures, 32-bit adder design

TI C6OOO 的LED实用程序，初学者必读-LED practical procedures, mandatory beginners