阵列ccd511驱动，微处理器的使用

15路电器遥控器的设计 原程序和必要的说明 很详细的 并且很好用-15 remote-controlled electrical path of the original design procedures and the necessary explanations very detailed and very good use

1.将P1.0～P1.3接开关，将P1.4～P1.7接发光二极管。依据P1.0～P1.3开关状态控制P1.4~P1.7发光二极管点亮。 2.将P1.0～P1.7全部接发光二极管，开始P1.0、P1.5点亮，左循环50次后P1.1、P1.4点亮；右循环30次，循环往复。-1. P1.0- P1.3 will then switch to P1.4- P1.7 access LEDs. P1.0- P1.3 based on state control switch P1.4- P1.7 LED lights. 2. P1.0- P1.7 will take all LEDs started Schematic, P1.5 lit, the left circle after 50 P1.1 and P1.4 lit; Turn right circle 30 times repeated.

机械产品控制器，控制了变频器，并且接入了很多开关量信号-mechanical products controller, control of the converter, and a lot of access off Signal

液晶驱动C程序,SSD1783芯片,液晶型号1760B0-LCD-driven C program, SSD1783 chips, liquid crystal models 1760B0

[推荐]彭光红先生的《小容量单片机系统的C语言程序结构》Point RTOS monolithic integrated circuit real-time operating system -[Recommended] Mr. Peng Guanghong

如何为keil c51编写仿真机的驱动程序-how to prepare simulator decoder drivers

采用tenx TMU3110开发的一个HID的示例程式 包括单片机程式 ,PC端USb接收程式-used tenx TMU3110 development of a program HID examples include SCM programs, PC program receiving end USb

用MSP430单片机的汇编语言写的串口接发程序-with MSP430 assembly language to write the serial process of sending and receiving

老外写的基于arm的sd/mmc读写程序，开源的项目-foreigner was based arm of sd/-3.4 reading and writing procedures, open-source project

ARM程序，很好的学习资料-ARM program, good learning materials