A character overlay module' s source code, mainly for the characters superimp...

单片机的PS/2接口程序! 我花了好大功夫写成的两个读写PS2设备的接口程序! 现在介绍PS24 书太少了!给大家借鉴啊!-SCM PS/2 interface program! I spent a lot of written work to read and write two PS2 equipment interface program! Book now introduced PS24 too little! To everybody"s reference ah!

这个是实时时钟芯片DS1302的驱动程序，采用c51编写，编程时只需要修改一下SCL,IO,RST的引脚定义即可，经过测试，完全好用-This is a real-time clock chip DS1302 driver, using C51 preparation, programming, only need to modify about SCL, IO, RST pin can be defined, tested and fully use

在有线电视中实现程控有源滤波器设计。为了充分利用设备和传输线,需要一种具有频率选择的网络―滤波器,将同一线 路上不同的信号分开,在电视机中也需要不同的滤波器(即选择有用信号,抑制无用信号) 。下面利用8051 单片机与12 位分辨率的DAC1208 数模转换芯片相结合的系统实现时间常数可程控有源滤波器设计,阐述了硬件结构与软件设计-In cable television in the realization of program-controlled active filter design. In order to make full use of equipment and transmission lines, the need for a frequency selective network- filter, the same lines separate different signal in the TV also requires a different filter (ie, choice of useful signals and suppress unwanted signals). Following the use of 8051 and 12-bit resolution digital-to-analog converter DAC1208 chip combining system time constant can be program-controlled active filter design, the hardware structure and software design

51PS2,单片机+PS2-51PS2, microcontroller PS2

avr 128 详细中文资料，很不错的噢-avr 128 detailed Chinese data, it is good Oh

这是LCD1602与msp430之间的通信,其实可以直接从51移植过来,但是一定要在硬件加上拉电阻,要不然是不通不过的,我说的是你用的是5V的LCD-This is the LCD1602 and communication between the MSP430 can in fact be a direct transplant from the 51, but must be coupled with pull-up resistor in the hardware, otherwise it is unreasonable, however, I say is that you use the LCD is 5V

一种无线传感器网络CSMA协议的设计与实现-csma

16x16LED 点阵屏源代码和电路图，可以实现上下移，左右移-Dot-matrix screen 16x16LED source code and schematics can be achieved on the lower left and right shift

一个单片机的频率计程序，能测试相应的频率-A microcontroller frequency counter program, capable of testing the frequency of the corresponding

NEC 3.5 lcd 驱动原理图-NEC 3.5 lcd driver schematic