msp430单片机控制小灯键盘程序,这是我搞的很熟的程序

关于msp430单片机的一些 自己收集的一些有需要的请下载-MSP430 MCU on some of his own collection of some of those in need, please download

此源码利用单片机实现以太网接口，实现方法简单，实用。-use of this source MCU Ethernet interface method is simple and practical.

密码锁:根据设定好的密码，采用二个按键实现密码的输入功能，当密码输入正确之后，锁就打开，如果输入的三次的密码不正确，就锁定按键3秒钟，同时发现报警声，直到没有按键按下3种后，才打开按键锁定功能；否则在3秒钟内仍有按键按下，就重新锁定按键3秒时间并报警-Password Lock: According to set a good password, the password used to achieve two key input function, when to enter the correct password, the lock will open, if entered incorrect password three times, on the lock button 3 seconds, also found that alarm sound, do not press the button until the three kinds of after the Open button lock function otherwise, there is still a matter of seconds in the 3 button press, on the re-lock button 3 seconds time and alarm

LT_1B msp430开发板例子程序－UART_U1152-LT_1B msp430开发板例子程序－UART_U115200

这是一个控制两个步进电机的程序，可以作为小车的驱动电机程序，实现正、反转、转弯等功能-This is a stepper motor control of the two procedures can be used as the drive motor vehicle procedures, implementation is, reverse, turning and other functions

这是一个串行通信接口的实例就是在单片机时钟频率在12MHz 波特率 9600bps 的通信方式下实现软件UART的发送程序。 -This is an example of serial communication interface is a single chip at 12MHz clock frequency in the communication baud rate of 9600bps software UART implementation of the send process.

*PC和ATMEGA128通信，ATMEGA以轮循方式发送，中断方式接受*-* PC and ATmega128 communications, ATMEGA sent to Round Robin, interrupted to receive*

利用51单片机及其接口电路模拟DMA的控制过程，由于数据的传输实际上不经过CPU而直接由A/D转换芯片传送到存储器，从而实现了数据的高速传送。-The use of 51 single-chip circuit simulation and its interface DMA control process, because the data transmission does not actually read the CPU and directly from the A/D conversion chip is sent to memory, thus realizing high-speed data transmission.

C8051F52xA_53xA型单片机ADC驱动源代码-C8051F52xA_53xA-based single-chip ADC driver source code

非接触式IC卡编程样例232-C3-non-contact IC card programming sample 232-C3