单片机在红外测温上的开发应用.对于正在开发红外测温的工程师有一定帮助...

使用结构体形式编写的串行通信的例程，供需要的人参考-Using the structure prepared in the form of serial communication routines for those who need it for reference

独立数码管计数，从0到99的计数，然后再清零。比较简单的代码。-Independent digital control counts, 0-99 from the count, and then cleared. The code is relatively simple.

本文档详细的介绍了51单片机的程序设计方法-this document detailed account of the 51 Microcomputer Program Design

带T6963C控制器的LCD的驱动程序和简单的显示测试程序-T6963 controller with the LCD driver, and the simple test procedure shows

一个很不错的按键单片机C程序-a very good button SCM C Program

PIC汇编语言样例程序集一，非常好的芯片驱动-PIC assembly language sample program sets a very good driver chip

8051 Serial I/O Routines Ring buffered, interrupt-driven UART driver, written in Keil C .

用C51单片机实现的无线数据传输例程,注意此程序为发送端程序,需要接收端给予配合-MCU with C51 wireless data transfer routines and procedures to the attention of this software, the need to cooperate receiving end

LED灯控制程序，用78F9212单片机，C语言，PWM控制，可调光-LED lamp control procedures, using 78F9212 Singlechip, C language, PWM control, dimmable

CRC16，C语言运算源码，包括四种算法，直接计算法，半查表法，全查表法，双8位表全查表法，适用于工业控制领域校验通讯数据使用，和MODBUS数据校验，在对不同的系统资源的要求环境下，采用不同的算法-CYXLIC REDUNDANCY, C language source computing, including four algorithms, direct calculation method, semi-look-up table method, the whole look-up table method, dual eight-wide table look-up table method, applied to the field of industrial control the use of calibration data communications and MODBUS calibration data in different systems of the requirements of environmental resources, mining different algorithms