这是12864与复位字体显示子程序显示初始屏幕…

国标 DLT-1997 645通讯协议 汇编代码-645 communication protocol assembly code

一个好用的整数分频电路 保证你喜欢 能够实现对任意整数的分频电路设计-a handy integer frequency divider circuit assures you like to be able to achieve arbitrary integer frequency circuit design

汇编语言编写的TI54xxd的带通滤波器程序-assembly language TI54xxd prepared by the band-pass filter process

usinf pic16c57 to achive copy machine for pic16c65/66(programmer)-usinf pic16c57 to achive copy machine for p ic16c65/66 (programmer)

SC6121发射芯片的解码程序,MCU有AT89C51-SC6121 chip decoder launch procedures, MCU has AT89C51

墨香的開區服務端 以及原墨香源碼可作修改作出新系統 修改語言為三種C/C++/C#整個檔案包括整個墨香的程式檔 全部整個可以修改

单片机实验板自检程序， 汇编语言编写，可检测实验板上所有功能-Self-test procedures for single-chip board, assembly language development, can detect all the features of the experimental board

设计一种自动洗衣机的程序控制器，在启动后先进水，等到达高水位后，启动洗衣马达转动4min，如在洗衣过程中发现水位低于高水位，则停止洗衣马达转动并报警，并在水位到达高水位后再次启动马达。洗衣结束后则启动排水开关，待水位到达低水位后，则启动脱水马达，转动2min。如此重复三次，要求在每一动作之间有2s的间隔。 高水位，低水位为水位传感器，用两个开关模拟，当水位高于高水位或低于低水位时，两个开关的状态分别为0 。启动开关用一个开关表示。进水、排水、洗衣马达、脱水马达及报警分别用一个发光二极管表示。本实验只需用可编程并行接口电路的A口。其硬件接口如下图所示。也可采用可编程逻辑器件进行设计。 -Design of an automatic washing process controller, after commencement of advanced water, and so on to reach the high water mark, start laundry motor rotation 4min, such as in laundry water level lower than that found during the high water mark, then the motor stops rotating laundry and alarm, and the the water level reaches the high water mark again to start the motor. Laundry is started after the end of the drainage switch, when the water level reaches the low water level, then start the dehydration motors, rotating 2min. Repeat three times, each action requires the interval between the 2s. High water, low water level as water level sensors, with two analog switches, when the water

依照个人成绩进行考核,这是程序的主界面，主要包含其他模块的调用等-that is a programe for education

创建MFC,在编辑界面创建所需的控件，并于Properties中将ID,Caption按表填好，给复选和编辑框控件连接变量，对消息处理函数加入指定代码。-Create MFC, in the editing interface to create the necessary controls and Properties Lieutenant ID, Caption completed table to check and edit the control box to connect variables, on the message processing function by adding the specified code.