S3C2410开发板的原理图参考

ecos diagprintf for powerpc and shared cariable usage

PXA310 DATASHEET_1, -PXA310 DATASHEET_1, PXA310 DATASHEET_1,

adc0809采集程序，led显示-adc0809 acquisition program, led display

This example program shows how to configure and use the A/D Converter of the following microcontrollers: * Philips LPC 2114/2119/2124/2129/2131/2132/2138/2194 After configuring the A/D Converter, the program reads A/D channel 0 and outputs the converted value using the serial port. To run this program... 1. Select the Device (Project - Options for Target - Device) 2. Build the project (Project - Build Target) 3. Start the uVision Debugger 4. Open the Serial Window (View - Serial Window 1) 5. Click Run (F5) 6. Click on the Toolbox buttons to change input voltages A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change. Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. µ Vision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals grap

ARM Cortex-M3 系列处理器 的实验代码，内容很全，涉及片内和外围所有部件编程。（Keil环境）-ARM Cortex-M3 family of processors experimental code, content is very wide, involving all the components and peripherals on-chip programming. (Keil environment)

阳初S3C2440开发板说明 值得看一下-Yang early S3C2440 development board that is worth a look

AVR128L DS18B20液晶显示的程序 绝对好使，改一下接口便可应用-AVR128L and ds18b20 display

The ATF1502BE device is an In-System Programming (ISP) device. It uses the industry-standard 4-pin JTAG interface (IEEE Std. 1149.1), and is fully compliant with JTAG’s Boundary-scan Description Language (BSDL).

EasyARM2131开发板源码之一___________1．GPIO输出实验－蜂鸣器控制-EasyARM2131 development board ___________1 one source. GPIO output experimental- control buzzers

ST7920驱动器的可实现程序，使用51/52单片机接口正确即可显示-ST7920 drive can be realized, the use of 51/52 single-chip interface to display correctly