Epson 150II点阵式打印机电路原理图,PCB图,有四个版本,CPU有LPC764,89C51RD2等,有驱动宽度保护功能....

Tea5767的3线控制程序，M8单片机，采用3线控制，内有电路原理图，可手动指定频率，也可以上下搜索-TEA5767 the 3-wire control procedures, M8 MCU, using 3-wire control with a circuit schematic can be manually specified frequency, can also be upper and lower search

是一款DA板卡的控制界面的原代码. 用VISUAL BASIC编程-Card is the control interface of the original code. Visual Basic

LED条屏显示程序,但是对初学者，尤其是苦于类似毕业设计的人应该有些帮助。 -Article LED screen display program, but for beginners, in particular, suffer from a similar design should be graduating from some help.

51单片机控制18B20传感器，利用液晶显示也可以利用数码管显示-51 Singlechip 18B20 control sensors, the use of liquid crystal display can also use digital tube display

51bote 单片机波特率设计助手-Single-chip baud rate 51bote Design Assistant

单片机直接驱动液晶模块, 可以值得大家参考一下-MCU directly drive LCD module may be worthwhile for your reference

这是一个周界报警的报警控制程序,采用89C52芯片,KEIL 51开发!-This is a perimeter alarm alarm control procedures used 89C52 chip development KEIL 51!

atmega16L的LCD经典试验已经通过验证-atmega16L the LCD classic trials have been validated

用MCS51系列单片机开发的交通灯控制程序-MCS51 series single-chip with the development of the traffic lights control procedures

本程序有友善之臂提供，为2440开发板的示例程序，请使用ADS编译。 简单使用说明： 使用H-Jtag或者更高级的仿真器调试，也可以不使用仿真器，借助supervivi的Download & Run功能测试， 下载的时候把DNW的下载地址设置为 0x30000000 即可。 本程序支持如下LCD: - NEC3.5"真彩LCD，分辨率240x320 - 7寸真彩LCD, 分辨率800x480 - VGA扩展模块,分辨率1024x768@70Hz 若要在LCD上正常显示CMOS摄像头，只需在Option.h文件中 改变LCD_TYPE的定义为相应的LCD即可。-This procedure has the arm of a friendly offer for the 2440 development board of the sample programs, use the ADS compiler. Simple instructions: Use H-Jtag or more advanced emulator debugging, you can not use the simulator, with the supervivi functional tests Download & Run, download time to download DNW address can be set to 0x30000000. This procedure supports the following LCD:- NEC3.5 " true color LCD, resolution 240x320- 7-inch true color LCD, resolution 800x480- VGA expansion modules, the resolution to 1024x768 @ 70Hz on the LCD display in the CMOS camera, only Option.h documents need to change the definition of LCD_TYPE corresponding to the LCD.