dsp SCI异步串行，自动波特率设置样例

源程序是在VisualDSP环境下开发出来的，目标处理器是4片AD公司的TS1O1 DSP。IDE_FAT32用来在硬盘上创建FAT32文件系统；2）i2c_test编写IIC总线；3）codec_a_in_pal_cf_frame是加载到FLASH的程序，板子在脱离PC自动上电时会把PAL制的图像直接存到CF卡里，CF卡的文件系统是FAT16；4）codec_a_in_pal_buf_boottest是可加载的DSP图像直通程序；5）ADSP-TS101prog_driver是flash的驱动程序。-source of the VisualDSP environment developed, targeted four processor is the company"s AD TS1O1 DSP. IDE_FAT32 used in the drive to create FAT32 file system; 2) to prepare i2c_test IIC bus; 3) codec_a_in_pal_cf_frame FLASH is loading procedures, the board automatically from the PC on when power will be the PAL system images directly to CF card, the CF card is the FAT16 file system; 4) can be loaded codec_a_in_pal_buf_boottest DSP image through procedures; 5) ADSP-TS101prog_driver flash is the driver.

一个小的测试程序，介绍dsp/bios德prd模块与log模块的使用-a small test procedures introduced dsp/bios Germany prd module and the use of log module

DSP操作外部FLASH,包括擦除、单字节读写、块读写-external FLASH DSP operations, including the erasure, single-byte read and write, read and write block

5416完整例程，包含所有完整编译文件，已成功编译过-5416 integrity routines, including a complete translation of all documents, has been successfully compiled

介绍关于dsp方面的嵌入式研究生论文-Introduction on the aspects of embedded dsp graduate thesis

利用北京青云的128×64的台湾硒创的ST7920的液晶显示程序，利用高效的总线并行访问，非串行，访问CGRAM,具有图形显示功能，可用在实时波形计算显示-Beijing Qingyun use the 128 × 64 selenium created in Taiwan

DSP培训 作业【源码】 -DSP training operations [Source]

TCPIP移植到DSP上的工程源码，包括与RTL8019以太网接口的程序。-TCPIP transplanted to DSP on the project source code, including those related to RTL8019 Ethernet interface procedures.

DSP程序员高手进阶，是学习DSP的好帮手，使你的编程上一个台阶-Master advanced DSP programmers and is a good helper to learn DSP to make your programming to a higher level

小波变换技术程序采用数字信号处理dsp。这种方法提供了时域和频域的信号处理