USB转CAN的采集卡程序，可以采集CAN总线的报文

串口操作源程序，可以对串口读写操作，当然也可以自发自收，是一个联系串口通信的好例子-source can write to serial port, of course, can also spontaneously collected, the serial link is a good example of communication

三菱PLC与PC通讯程序，只是简单做了试验，结果较好。-Mitsubishi PLC and PC communication program, but simply to do a test with satisfactory results.

要完成串口通信, 在32位模式下, 一般说来有以下四种方法-to complete the serial communications, in 32-bit mode, in general the following four methods :

51单片机的MODBUS的通信协议，学习中。

f2812串口通信接口B口，c语言,中断-f2812 serial communication interface B port, c language, interruption of

PLC串口编程,通过RS232和RS485与上位机通讯.-PLC serial port programming, through the RS232 and RS485 communication with the host computer.

SPCE061A 利用C语言进行软件端口位操作范例-SPCE061A C language for the use of port-operating software paradigm

这是用KeilC做的nRF9E5发射程序,可以用的,是做射频的好代码.-This is done using the nRF9E5 KeilC launch procedures can be used to be so good RF code.

Verilog实现的UART程序，用ISE打开工程文件即可-Verilog implementation UART program, open the project file with the ISE can be

DELPHI COMM控件 控件-DELPHI COMM Controls