单片机对DAC转换器的操作，很简便使用的。

这是DSP2407的RAM测试程序,含全部源码,调试通过,可运行.-This is the DSP2407 the RAM test procedures, including all source code, debugging is passed, can be run.

isd1420语音芯片源程序用KEI UVISION打开-isd1420 voice chip source with open KEI UVISION

方波产生程序 megal128 iccavr开发平台 -Square wave generation process development platform megal128 iccavr

T9 输入法. 可以方便地移值到单片机上使用. 可实验T9输入法.-T9 input method, which can transfer to singlechip system conveniently. It can implement the T9 input method.

单片机控制1420语音芯片发声程序。同时通过485通信方式与外界进行数据通信。-1420 single-chip control procedures audible voice chip. At the same time through the 485 means of communication with the outside world for data communications.

DAC1230是一个12位的模数转换的芯片!而使用时候是在8位的单片机上运行,所以需要注意高四位和低八位的写入时序-DAC1230 is a 12-bit analog-digital conversion chips! Use of time in the 8-bit single-chip run, so it is necessary to pay attention to the high four and low eight write timing

计算机简单控制由软件和硬件组成。软件由Visual Basic 6.0编写。硬件主要由无线发送模块和单片机（C语言编写）构成。通过RS232界面与PC通信而实现无线控制系统。 主要功能是：通过遥控器连接PC机的"上下左右"按键 ,当电脑界面处于powerpoint界面下,能通过遥控器控制幻灯片的上下切换. -Simple control by the computer software and hardware components. Software prepared by the Visual Basic 6.0. Hardware mainly by the wireless sending module and single chip (C language) constitute. Through the RS232 communication interface with the PC wireless control system. Main function is to: Connect PC through a remote control machine up and down about button, when the computer interface in a powerpoint interface via remote control to switch slides up and down.

ADUC845单片机的一些C程序，包括AD、DA 、定时器等-ADUC845 SCM some C procedures, including AD and DA, timers, etc.

在软件proteus下仿真MCU-51单片机6位LED计数器的演示例子和完整源代码(keil工程)-in software simulation under MCU-51 6 LED counter demonstration examples and complete source code (c51 engineering)

一个完整的51单片机的操作糸统源程序! 内容十分丰富!很有借鉴价值!-a complete 51 MCU operating range EC source! Very rich! Very valuable reference!