博创UP

easy arm2210下GPIO的例子,主要说明如何使用GPIO-GPIO under easy arm2210 examples, mainly explains how to use the GPIO

ucos在blackfin533上的移植。用ADI的visual dsp++ 编译。如果编译不能通过，请将*.ldf删除，让系统自动生成ldf文件。-CENTER blackfin533 in the transplant. Using ADI"s visual DSP compiler. If you compile passed, I would be grateful if*. ldf deleted, so that the system automatically generate ldf document.

ucos-ii中互斥信号mutex建立源码-ucos-ii in the establishment of mutually exclusive mutex signal source

lpc1768 uCgui工程模板代码，结构清晰。(Lpc1768 uCgui project template code, structure is clear.)

主要实现功能： 1 tcp server并发（主要涉及文件app_lwip.c、app_tcp_server.c） 2 网线热插拔（主要涉及文件app_lwip.c、app_tcp_server.c） 3 不重启修改ip地址（主要涉及文件app_lwip.c、app_tcp_server.c、app_key.c（按键修改ip地址）） 4 将lwip的数据接收从中断方式改成单独的接收任务方式（主要涉及文件app_lwip.c） 5 usb串口信息打印（115200波特率） 6 注意：使用的stm32的HAL库而不是标准库(The main functions are: 1 TCP server concurrency (mainly related to file app_lwip.c, app_tcp_server.c) Hot plugging of 2 network lines (mainly related to documents app_lwip.c, app_tcp_server.c) 3 do not reset the IP address (mainly related to file app_lwip.c, app_tcp_server.c, app_key.c (key modify IP address)) 4 change the data reception of LwIP from the interrupt mode to the individual receiving task (mainly involving the file app_lwip.c) 5 USB serial port information printing (115200 baud rate) 6 note: the HAL Library of the STM32 used instead of the standard library)

一个AT91SAM7X256 USART驱动实验，硬件环境为at91sam7x-ek开发板，开发环境为iar。-An experimental AT91SAM7X256 USART driver, hardware environment at91sam7x-ek development board, development environment for iar.

keil for uCOS_II v2.52

uCOS-II 2.52在intel 80x86上的移植程序(大模式,实模式）-uCOS-II 2.52 intel 80x86 in the transplant procedure (large model, real mode)

install ucos on floopy

这个是UCOS的源代码，大家有兴趣可以-this the source code, you can be interested in reading