以ARM处理器为核心的新一代称重处理器 （欢迎从事电子衡器行业的同行指正）

基于ARM9的嵌入式GPRS的设计与实现,用基于ARM核的S3C2410微处理器-ARM9-based embedded GPRS design and implementation, with ARM core-based microprocessor S3C2410

FREESCALE 16位单片机片MC9S12DG128的PWM输出程序,可设定PWM波的频率和占空比由产品验证,完全可用-SCM MC9S12DG128 PWM output procedures, configurable PWM pulse frequency and duty cycle from product certification, fully available

S3C2410完全开发流程,实验源码,．S3C2410 基础实验 -S3C2410 fully developed flow, the experimental source. S3C2410 based on experimental

凌云逻辑CS4360音频DAC的参数设置代码，缺省为I2S六声道。- Reaches the clouds logical CS4360 the audio frequency DAC parameter establishment code, lacks the province is the I2S six sound tracks.

用于控制codec的iic源码，譬如SAA7105或saa7115等codec芯片。-IIC codec is used to control the source, for example, or the SAA7105 chip saa7115 and other codec.

到IDE硬盘和44B0阶段，然后把这个IDE3.C添加内核编译完成后，打开驱动器就可以抓到这个了

这是一个基于ATMEL的ARM9的原理图,经过本人的修改.-This is a based on the ARM9 ATMEL schematics, I read the amendment.

s3c44b0,开发板上测试usb的host/device的源程序，ads调试通过-s3c44b0, development board test usb the host/device source, Debugging through ads

lpc2292 can

步进电机是将电脉冲信号转变为角位移或线位移的开环控制元件。在非超载的情况下，电机的转速、停止的位置只取决于脉冲信号的频率和脉冲数，而不受负载变化的影响，即给电机加一个脉冲信号，电机则转过一个步距角。-Stepper motor is the electrical impulse signals into angular displacement or linear displacement of the open-loop control components. In the non-overload case, the motor speed, and stop location depends only on pulse frequency and pulse number, regardless of the load change, that is, to add an electrical pulse signal, then turn one motor step angle.