卡尔曼滤波

STM开发板自带IAP程序,适合需要熟悉STM单片机的人学习使用-STM development board comes with IAP program, suitable for people who need to know to learn the use of STM Microcontroller

每次开机都将次数加1 并存储到EEPROM。这样就能直观的看到机器的使用次数。用P1口 LED做为显示，次数大于256是将溢出，按复位模拟开机 或者直接通过开关开机。-Each boot will add a number of times and stored in EEPROM. This will be able to see the intuitive usage of the machine. As with the P1 port LED display, frequency is greater than 256 is the overflow, according to reset the boot, or directly through the analog switch boot.

S3C2440处理器上的CF卡读写程序，已经通过验证。-S3C2440 processor CF card reader procedure has been validated.

本文为采用VHDL编写的程序及报告。步骤如下：1设计三位二进制计数器程序 二:设计一驱动循环显示7位数字 2编写LED控制程序如下： 3设计采用原理图方式如下: -VHDL paper prepared for the introduction of procedures and reports. Steps are as follows : Design of a binary counter three two procedures : Design of a drive cycle show seven figures prepared two LED control procedures are as follows : three designs diagram as follows :

有关sja1000的can总线驱动 其中包含详细的Makefile很好用-Sja1000 the can on the bus driver Makefile contains useful detailed

单片机课程实验，微机接口实验程序源码 包括8088等芯片-Singlechip course experiments, computer source interface Experimental procedures including the 8088 chip, etc.

嵌入式下对IO口的读写，用C实现的，非常有帮助-Embedded under the IO port to read and write, using the C implementation, very helpful

UIP TCP/IP 堆栈被为了使它有可能即使使用 tcp/ip 协议进行通信关于小 8 位微控制器。尽管是小而简单，uIP 不需要他们的同龄人有复杂的全尺寸的栈，但可以和运行同样的轻重量堆栈的同龄人交往。代码大小是几个字节和 RAM 使用量可以配置为可低至几百字节为单位）。

use keil to program this code.

嵌入式系统讲义幻灯片课件- Inserts the type system printed lecture slide class