dsk6416关于CSL片上支持库的edma例程~~~可直接运行

dsp2812的合众达串行通信程序，可以用来参考，一切头文件都加载到里面了不只可以做SCI测试-Tatsu of the United dsp2812 serial communication procedures, can be used to reference all the header files are loaded into the inside of the SCI not only to make testing

本书主要是TMS320F2812的中文手册，方便大家的查阅-This book is mainly the Chinese manual TMS320F2812, convenient access to the U.S.

TMS320F2812通用IO口驱动程序-TMS320F2812 generic IO port driver

详细描述了,由DSP5402控制的ISP1362的初始化,以及设为HC模式的整个工作过程-Described in detail by the DSP5402 control initialization ISP1362, as well as the HC mode is set to the entire work process

用汇编写的dsp源代码，包括正弦波发生器、交通灯、滤波器，调试可通过。-Used to compile the source code written in dsp, including the sine wave generator, traffic lights, filter, debugging can be.

该代码采用c5400dsp的汇编语言和c语言实现正弦信号，经过实际测试，效果很好，正弦信号输出由dsp的同步串口输出-c5400dsp of assembly language and c language sinusoidal signal, after the actual test and the results very good, sinusoidal signal output from the dsp synchronous serial output

DSP TMS320C6713 EDMA数据传输程序，希望对大家有用。-DSP TMS320C6713 EDMA data transfer procedures, in the hope that useful to everyone.

基于DSP2407的CAN程序，用C语言编写，使用INT5中断完成-DSP2407 of CAN-based procedures, using C language, the use of complete interruption INT5

c语言编制的DSP硬件中断程序实验程序可在CCS中运行-DSP hardware interrupt procedures experimental procedure can be run in the CCS

C32中C语言中嵌入汇编程序示例.包括中断程序中调用C参数-C32 C language embedded assembler example. Including the interruption procedure called C parameters