debian系统下的串口调试器，它是用c++开发，具有window下的串口调试器的所有功能。...

模拟的i2c程序-simulation procedures i2c

eCos/RedBoot for勤研ARM AnywhereII(4510) 含全部源代码--eCos/RedBoot for Qin Yan ARM AnywhereII(4510), including all source codes.

应用背景 VB写的控制程序，通过PC端上位机控制，在电路板上实现相应的演示效果。  VB write control procedures, through the PC side of the upper computer control, on the circuit board to achieve the corresponding demonstration effect. 关键技术首先 烧写程序到单片机   晶振 11.0592MHZ连接好串口线打开上位机软件 选择好COM端口  设置波特率为9600 First of all burn to write programs to chip crystal 11.0592Mhz serial line connection open PC software select the COM port to set the baud rate of 9600

S3C2410的底层Bootloader的测试程序，有相应的USB驱动程序-S3C2410 bottom Bootloader test procedures, has the corresponding USB driver

一款低价位时钟芯片的C驱动程序-low-priced clock chip C Driver

附件程序是我用DSP2812开发的无刷直流电机控制程序，程序是在TI公司的BLDC3_1软件的基础上构造的，实现了无刷直流电机的速度环PID控制，效果可以。 其中，无刷直流电机是有HALL传感器的系统，所以在转速测量上还需要进一步的改进（如果要求精确的话）。电机是24V3000rpm～～～；驱动板是类似TI公司的DMC1500？板卡，所以可以参考它的说明（只针对信号的连接的参考）-Annex I use the procedure is the development of the DSP2812 brushless DC motor control procedures, TI is in the process of BLDC3_1 software companies on the basis of the structure, Implementation of the brushless DC motor velocity loop PID control, the effect can be. Among them, brushless DC motor are HALL sensor system So speed measurements need further improvements (if the precise words). Motor V3000rpm is 24 ~ ~ ~; Market-driven companies like TI DMC1500? Card, we can refer to it (only signal against a reference link)

嵌入式数据库Berkeley DB-4.5.20源代码-Embedded Database Berkeley DB-4.5.20 source code

本文件是用keil编程的电子表的设计，实现时，分，秒的加减，和定时功能-This document is an electronic programming keil table design, the realization of hours, minutes and seconds of the addition and subtraction, and the timing

简单的示例代码从芯片 pic18F 的 tft 液晶显示器的控制。只是画一些帆船，通过平行接口的访问。

嵌入式linux的开发流程详解，包括启动，内存，设备驱动的添加-embedded linux Comments on the development process, including the initiation, memory, add-driven equipment, etc.