数值转换程序，可以将十进制字符穿转化成二进制字符

走马灯（灯光变幻）程序 内容：用DIP的8位开关控制走马灯的花样，用SW3控制走马灯的起/停 运行步骤:1.按下一次开关SW3,开始灯光变幻,再按下一次则停止 可重复进行 * 2.按下SW3后，拨动不同的数码开关DIP,就会出现不同的灯光变幻 * 3.按下"q"或者"Q",退出 -Lantern (lighting changes) program elements: eight with DIP switch control of the pattern lantern, lantern used to control the effect SW3/stop running these steps: 1. Pressing a switch SW3, the beginning of the light changes, and then press the first stop can repeated* 2. SW3 pressed, the Touch different digital switch DIP, there will be changes in different lights* 3. press " q" or " Q" , from the

dos下的网卡驱动程序。支持一般通用网卡，intel的8139系列。-card under dos driver. Support the general use card, intel

PIC18F252/452 bootloader-PIC18F252/452 Bootloader

其中k1-k5,5个分程序可以单独执行，在k0程序中以子程序出现，注意：每个 程序作为子程序后，加上ret,去掉ljmp-Where k1-k5, 5 sub-programs can be individually implemented programs to subroutines in k0 appear NOTE: each program as a subroutine, coupled with the ret, remove ljmp

关于接口课程实验的一个源代码,需要有相关的实验平台配合使用-courses on the interface of an experimental source code, the need for the combined use of experimental platform

这是我自己写的关于H.264解码反量化(IQ)部分的ARM汇编程序.请版主给以指教,多谢!-that I write on the H.264 codec- quantization (IQ) of ARM assembler. Please enlighten giving moderator, Thank you!

51控制led顺序点亮, 通过控制p0.0使其能按不同的顺序 -Led the order of 51 to control light, through the control to enable them to p0.0 different order

在51的P1口连接8个发光2级管，实现8个发光2级管轮流显示-In 51 of the P1 port to connect eight light-emitting tube 2, the achievement of eight light-emitting display two pipe rotation

(中断子程序)计时子程序----------------ＣＬＯＣＫ 功能：①TMR1每50000指令周期(即50000微秒)中断一次, 进入本程序后重装定时器 TMR1, 并清除TMR1溢出标志(PIR1,0). -(Interrupt Subroutine) subroutine CLOCK timing functions: ① TMR1 every 50000 instruction cycles (that is 50000 microseconds) disruption of the first to enter this process re-timer TMR1, and clear TMR1 overflow flag (PIR1, 0).

用单片机制作的高精度计数器，验证通过，适用于计数场合。-Produced using high-precision single-chip counters, authentication is passed, apply to count occasions.