Touch Panel ocmj15X20 procedures

基于转换器的压力测量与精度分析-converters based on the pressure measurement and analysis accuracy

单片机设计的遥控电路，遥控码的脉宽数用红外线接收器解码后送单片机读入，发射时由单片机产生40KHZ红外调制信号送红外线发射管发射-Single-chip design of the remote control circuit, remote control code number of the pulse width decoder using infra-red receiver to read single-chip evacuation, launch generated by single-chip modem 40KHZ IR signal sent to the launch tube fired infra-red.

本代码基于凌阳SPCE061A芯片，实现波形发生器功能，能实现波形包括正弦波、方波、三角波、锯齿波，外括数码管显示，语音报数据的功能。-Based on this code SPCE061A Sunplus chips, realize waveform generator function, can realize waveforms including sine wave, square wave, triangle wave, sawtooth, outside, including a digital display, voice, data reported.

CS5532初始化代码，描述了配置寄存器、通道设置寄存器的C实现-CS5532 initialization code, describes the configuration register, the register set up the channel to achieve C

51单片机的IIC总线先测试程序，C语言编写，很实用的！-51 MCU IIC bus test procedures, C language, it is useful!

程序功能:本程序是利用文件240X.ASM中的子程序对EEPROM 240X进行多字节读写的操作示 例(同样适用于2416).-procedures functions : the procedure is the use of the document 240X.ASM subroutine right EEPROM 240X multi-byte read and write operations examples (the same applies to 2416).

基于16c54的4位LED时钟显示程序-16c54 based on the four LED clock display program

单片机程序可预置4位可逆计数器ASM.rar-SCM Program Files 4-bit reversible counter can be preset ASM.rar

用中断的方式控制lcd的显示，单片机仍然是h83664十六位单片机。此程序包含单片机的接口的配置以及各种写lcd的子程，使用中断来控制lcd顺序显示A－Z，当然，可以换成其他的显示内容，由于接口程序已经编好，只需要把要显示的内容改一下就可以实现其他内容的显示-With interruption control lcd display, single-chip is still 16 Singlechip h83664. This procedure includes the configuration of single-chip interface and a variety of writing a sub-lcd-way, the use of interrupt to control the order in lcd display A-Z, of course, can be replaced by other display content, as a result of interface procedures have been developed only to To display the contents of change can be achieved about the display of other content

你是单片机初学者吗？那一定很想有一些源程序和电路图指导你吧！？那就看看这个单片机实验用程序及原理图集吧-you SCM beginners? I certainly would like to have some source circuit and guidance you! ? Then look at the MCU experimental procedures and principles Atlas it