Verilog 的展位乘数

说明：  Verilog数字系统设计教程(第二版) 夏宇闻(Verilog Digital System Design Course (2nd Edition) Xia Yuwen)

采用Xilinx公司的Spartan6 FPGA设计PCI Express的详细参考资料(Xilinx' s PCI Express, Spartan6 FPGA design, detailed reference information)

AD9469 FPGA 代码  软件无线电前端 AD9469 Verilog 代码  FIFO后数据处理等

针对兆瓦级风电并网逆变器主电路研制中存在的并联扩容、开关频率较低和LCL滤波器难以优化设计等问题，提出了采用交流侧串接电感再进行并联的均流方案，采用载波移相技术提高变流器的等效开关频率，提出了LCL滤波器的设计原则，并给出了上述设计的理论依据和实现方法。通过对2兆瓦风电变流器主电路的仿真验证了上述技术方案。(MW-class wind power for grid-inverter main circuit of the parallel development of existing capacity, a lower switching frequency and LCL filter design difficult to optimize the problem, a series inductor AC side in parallel are further flow program, the use of carrier phase-shifting technology to enhance the equivalent converter switching frequency, a LCL filter design principles, and gives the above-mentioned theoretical basis for the design and implementation. 2 MW of wind power converter main circuit simulation program to verify the above-mentioned technology.)

Verilog最基本的源代码之一，位宽为4的二进制计数器。既可以实现计数也可以实现对时钟信号的分频，因此是Verilog入门非常实用的代码之一。在此代码基础之上，可以进行多种改变，实现不同的功能。

说明：  设计11位巴克码序列峰值检测器，巴克码相关器原理：巴克码相关器能够检测巴克码序列峰值，并且能够在1bits错误情况下检测巴克码序列峰值。(A 11-bit Barker code sequence peak detector is designed. The principle of Barker code correlator is that the Barker code correlator can detect the peak value of Barker code sequence and detect the peak value of Barker code sequence in the case of 1 bits error.)

说明：  QUARTUS2 16.9 VHDL FPGA ENDAT2.2

产生长度为100的随机二进制序列 发送载波频率为10倍比特率，画出过采样率为100倍符号率的BPSK调制波形（前10个比特） ，及其功率谱 相干解调时假设收发频率相位相同，画出x(t) 的波形，假设低通滤波器的冲激响应为连续10个1（其余为0），或连续12个1 （其余为0） ，分别画出两种滤波器下的y(t)，及判决输出（前10个比特） 接收载波频率为10.05倍比特率，初相位相同，画出x(t) 的波形，假设低通滤波器的冲激响应为连续10个1，画出两种滤波器下的y(t)，及判决输出（前20个比特） 采用DPSK及延时差分相干解调，载波频率为10倍比特率，画出a, b, c, d点的波形（前10个比特） DPSK及延时差分相干解调，载波频率为10.25倍比特率时，画出a, b, c, d点的波形（前10个比特） DPSK及延时差分相干解调，载波频率为10.5倍比特率时，画出a, b, c, d点的波形（前10个比特） (Produce random binary sequence of length 100 The transmission carrier frequency is 10 times the bit rate, draw a sampling rate of 100 times the symbol rate of the BPSK modulation waveform (first 10 bits), its power spectrum Coherent demodulation of assuming the same as the phase of the transmitting and receiving frequencies, and draw the waveform x (t), assuming that the impulse response of the low pass filter 10 consecutive 1 (the remainder is 0), or 12 consecutive 1 (the remainder is 0), y (t) is drawn under the two filters respectively, and the decision output (10 bits) The received carrier frequency is 10.05 times the bit rate, the same initial phase, draw the waveform x (t), assuming that the impulse response of the low pass filter of 10 consecutive 1, shown under two filter y (t), and decision output (20 bits) DPSK and delay differential coherent demodulation, the carrier frequency is 10 times the bit rate, draw a, b, c, d point of the waveform (first 10 bits) DPSK and delay)

UMC 90nm design kit. please read before using thee models.

假设每个从设备中有可访问APB寄存器16个，位宽均为32比特，16个寄存器的访问地址计算方式为 基址 +　寄存器编号左移２位（byte 偏移）(Assuming that there are 16 accessible APB registers in each slave device, the bit width is 32 bits, and the access address of 16 registers is calculated by base address + register number left shift 2 bits (byte offset).)