汇编程序原代码.

2410下一个最简单的程序，可以很轻松的由51过渡到ARM-2410 the next most simple procedure that can easily transition to the ARM by 51

写eeprom的c语言程序，在msp430单片机x1系列上调试通过-EEPROM write the c language program, in the MSP430 family of single-chip debugging through x1

用于并行接口实验，运行环境为Winxp Xingyan 集成环境-Parallel Interface for the experiment, operating environment integrated environment for Winxp Xingyan

This is an MCP2515 driver application using a PIC16F73, connected to the PC through the serial port. In the firmware you can easily configure the MCP in TX, RX or LOOPBACK mode.

自己做的程序，分享一下，希望大家多多指点，汇编语言学习的成果,包含了两个源代码，分别是（add和sub）-To do their own procedures, to share the hope that a lot of U.S. guidance, the compilation of the results of language learning, including the two source code, respectively (add and sub)

说明FPU算法和浮点运算的算法

Multisim9 电池设计 压缩包解压时不能有密码-Multisim9 battery design can not extract compressed package password

编写程序，程序运行时使PC机成为一架可弹奏的“钢琴”。当按下数字键1~8，依次发出1，2，3，4，5，6，7，I八个音调。按CTRL+C则退出“钢琴”状态。-Write a program, the program is running to make PC-1 may play into the " piano." When pressing the number keys 1 to 8, followed by issue of 1,2,3,4,5,6,7, I eight tones. Press CTRL+ C has withdrawn from the " Piano" state.

从首地址为1000H开始存放10个数，要求设计程序将这些数由小到大排序，排序后的数仍放在原地址处。-Starting from the first address 1000H store the number 10 to require the design process to sort these the number of small to large, sort after a few still on the original address.

使用51单片机实现时钟设计的仿真，有源程序以及Proteus的仿真图，希望对大家有帮助。-design clock。