ucos在avr上的移植代码，内核代码需要自己补齐

这是ucos在Freescale9s12XS128上移植成功并测试成功的代码(This is ucos in Freescale9s12XS128 successfully transplanted and successfully tested on the code)

ucos for arm 1176 porting

将本站的UCOSFORAVR128V276版本升级到了280版，修正原来的中断定义错误，并仿真调试已通过。-UCOSFORAVR128V276 the site will upgrade to version version of the 280, that the interruption of the original definition errors, and debugging simulation has passed.

说明：  ucos ii 移植到51上；仅供学习；无实际应用价值。(ucos ii run on mcs51;no value ;just for study.)

1.板上的8 个按键分别分别代表数字1-8，按下一个按键将结果通过串口发送到PC机上显示； 2.使用两个定时器模块，分别定时为1ms 和100ms 产生中断，使用它们分别 产生1s的定时时间，将时间分别显示到数码管上； 3.外接PS/2小键盘，将按键的值通过串口显示到PC机上。(A panel of eight key representing the number 1-8 press a key the results sent through the serial port on a PC display (2) use two timer modules, respectively, of 1ms and 100ms timer generates an interrupt, use them, respectively, Produce the timing of the 1s, the time display to the digital control External PS/2 keyboard, the key value of displayed through the serial port to a PC.)

ucosii4sk

一个AT91SAM7X256 CAN通讯实验，硬件环境为at91sam7x-ek开发板，开发环境为iar。-An experimental AT91SAM7X256 CAN communications, hardware environment at91sam7x-ek development board, development environment for iar.

说明：  stm32f103芯片ucosii例程，经测试，可用(UCOSII routine of STM32F103 chip)

该文件为uCOS-II实时嵌入式操作系统的详细使用教程，代码分析及源代码。教程中对uCOSII中代码各部分功能和模块分章列出，希望对使用和移植的朋友能够有所帮助。-This document gives uCOS-II real-time embedded operating system, the detailed use of tutorials, code analysis and source code. Tutorial on the uCOSII in various parts of the code features and module sub-chapters are listed in the hope that the use and transplantation of a friend can help.

此代码是我精心调试而成，内有NOKIA3310驱动，无刷电机驱动，还有UCOS嵌入式操作系统，在电路板上调试成功-This code is from my well-debug, which have NOKIA3310 driver, brushless motor drive, there are uCOS embedded operating system, the success of the circuit board debugging