AD转换用的很广泛的一款芯片的资料，觉得好分享了 大家用得时候可以尽管下！...

这是自己写的关于PS2键盘接口的程序，和单片机的接口，用汇编写的，测试成功，与图形点阵液晶联合使用，不过液晶程序没有上传-This is his writing on the PS2 keyboard interface procedures, and the microcontroller interface, with a compilation of written test successfully, and graphics dot-matrix LCD joint use, but not to upload procedures LCD

主要针对pic单片机的片内资源应用，通用性比较强-Targeted pic microcontroller chip resources in the application of relatively strong versatility

凌阳单片机的遥控解码介绍和应用，pt2262、pt2272编解码遥控系统-Sunplus SCM introduction and application of remote control decoders, pt2262, pt2272 codec remote control system

16*16点阵源C程序，keil开发,可以显示32个字,从左到右滚动显示。-16*16

C51单片机开发板电路和源代码，很详细，内部有该开发板的说明。顺便感谢下制作的公司-C51 single-chip development board circuit and the source code, very detailed and has an internal description of the development board. Incidentally, thanks to the production company under the

LPC单片机I2C编程-LPC SCM I2C programming

测试频率 基于C8051F330单片机的频率测试 频率测试精度：0.1Hz-testing frequency C8051F330 microcontroller based on the frequency of testing frequency accuracy : 0.1Hz

x25045的编程应用，它具有512字节的EPROM，看门狗，复位信号等，是MCU不错的外围芯片-x25045 programming application, which has 512 bytes of EPROM, watchdog, reset signal, MCU is a good peripheral chips

本设计的由单片机控制的自动加料系统是与料斗式干燥机配套的加料系统。根据加料工艺要求，其工作原理是：先将真空管关闭，启动电机，用低真空气流将塑料树脂粒子送入真空管，电机停转，再将粒子排入料斗，如此循环。-The design of single-chip microcomputer controlled by the automatic feeding system with hopper dryer feed supporting system. Charging process in accordance with the requirements of its working principle is: first vacuum tube to close, start motor, using low vacuum plastic resin particles will flow into the vacuum tube, the electrical switch to stop, and then particles into the hopper, and so the cycle.

pic单片机c语言教程，microship公司工程师写的技术文章，对使用pic的c编程很有帮助，本文章是中文版。-pic microcontroller c language guides, microship Company engineers to write technical articles, the use of the c pic programming venture, the article is the Chinese version.