在uclinux／linux下通过串口以ＸＭＬＯＡＤ协议与ＰＣ终端通讯，可以实现从ＰＣ到平台的文件下载．...

资源描述你的单片机5V和步进电机工作需要12V的操作。因此，微控制器端口引脚不能驱动电机自己。他们需要一种叫做驱动电路的东西。该电路通常需要从控制器的低电平信号，并将它们转换为高电压/电流信号，这是能够令人兴奋的定子绕组。

Ｃ８０５１Ｆ０４０的ＡＤＣ０单端输入模式，定时启动，由Ｔ２定时，选择ＡＩＮ０.３为ＡＤＣ０转换通道-C8051F040 ADC0 the single-end input mode, the regular start, the T2 timing, ADC0 AIN0.3 choice for channel conversion

PIC16F876A制作数控电源(完整C程序+HEX+仿真+电路图) 源代码，protues仿真图，电路图全套-NC PIC16F876A power production (complete C program+ HEX+ Simulation+ circuit) source code, protues simulation map, a full set of circuit

直升机模型自动控制系统，包括上位机和控制系统-helicopter model control systems, including PC and control systems

使用tasking for mc683XX C编译器-tasking for the use of the C compiler mc683XX

用verilog写的基于cpld的交通灯控制器的源代码，供参考-Use verilog to write cpld-based traffic signal controllers and the source code for reference

sharp的arm920t 7A400的评估板附带光盘Sharp KEVLH7A400 v0.3b Welcome to the SHARP KEV7A400 Evaluation board beta starter kit. This document contains last minute updates to the kit and/or documentation that were not available at the kit development time.-sharp arm920t 7A400 of the Evaluation CD-ROM attached Sharp KEVLH 7A400 v0.3b Welcome to the SHARP KEV7A400 Evalu ation board beta starter kit. This document con tains last minute updates to the kit and/or docu Sommet that were not available at the dev kit elopment time.

数据采集卡德PC端应用程序代码，有图形界面-Data Acquisition Card PC-side application code, there is a graphical interface

红外遥控码的接收程序，适用于pt2222,nec 6211 等--Receiver program for remote infrared encoding. It could be used in pt2222, nec 6211, and etc.

STM32_PLC_CODE，在STM32平台上直接移植，能实现基本的PLC功能指令，仅限学习之用。-