X5045 procedures, you can run keil c

CAN通讯 有源程序 很好 大家来看看 SJA1-CAN communications have a very good source to look at the U.S. SJA1

采用IAR进行编译。 这是ATMEGA128单片机的BOOTLOADER的源码。 和AVRSTUDIO配合使用。 具体请参考bootloader.c的注释说明。 如有任何问题请邮件联系。-used for IAR compiler. This is ATMEGA128 SCM BOOTLOADER source. And the use of AVRSTUDIO tie. Please refer to specific bootloader.c note of the Notes. If you have any questions please contact mail.

有遥控的温度计,用dS1302做时钟芯片，Ds18B20做温度芯片-There are remote thermometer with clock chip DS1302 do, Ds18B20 do temperature chip

One study shows that Americans prefer to answer with a brief

视觉暂留，编程从一个I/O口输出一扫频信号，驱动一支LED灯闪动，频率范围为10HZ~99HZ，扫描时间为30秒，在LED闪动期间观察，一旦发现无法识别LED灯闪动时，按下按键K1，立即停止输出，并将此时的信号频率显示在数码管上，该信号的周期为测试者的视觉暂留时间。-Persistence of vision, programming from an I/O port outputs a sweep signal to drive an LED light flashing, the frequency range of 10HZ ~ 99HZ, scan time of 30 seconds, the LED flashing during the observation, once found it impossible to identify the LED lights flashing, press the key K1, immediate cessation of the output, and at this time the signal frequency displayed on the digital control on the test cycle of the signal" s persistence of vision time.

银杏科技有限公司dsp实验开发板的实验程序-Ginkgo Technology Co., Ltd. dsp development board Experimental Experimental procedures

C51与HT9170和HT9200接口程序(双音多频)-C51 with HT9170 and HT9200 interface program (DTMF)

我最近找的一些关于ADS1252的资料,还有源码,我已经编译过啦-Recently, I find some of the information on the ADS1252, and the source code, I have compiled Matata

代码为单片机与液晶模块的接口电路程序以及显示程序，适用于用单片机实现液晶模块显示的初学者-Code for the microcontroller and LCD module interface circuit procedures and display program for display LCD module with MCU for beginners