基于51的动态内存管理

基于国旗升降控制系统的设计与实现，采用汇编语言设计源代码。-Based on the national flag take-off and landing control system design and realization of the design using assembly language source code.

键盘与显示，按下相应的按键，数码管就显示相应的数字-The keyboard and display, press the corresponding button, digital controls, it displays the corresponding figure

AD转换芯片max197驱动程序（KeilC51）-AD converter chip max197 Driver (KeilC51)

51单片机编程序学习实践经验丰富工程师编写实机通过-51 SCM-programmed study and practice of experienced engineers to prepare real machine through

用步进电机画图的完整原代码，集成50多种图形-Stepper motor used to draw a complete source code, integrated more than 50 kinds of graphics

八路电压表C程序 使用AT89C52单片机，12MHZ晶振，P0口读入AD值，P2口作AD控制，用共阳LED数码管 P1口输出段码，P3口扫描，最高位指示通道（0-7）。-Eight-way voltage meter C program using AT89C52 single-chip, 12MHZ crystal, P0 I read into the AD value, P2 I make AD control, with a total of P1 Yang LED digital tube output above code, P3 port scan, the maximum channel bit instructions (0-7).

基于c8051f020的基本程序，在此基础上可以做很多你想做的事情，只要你看懂该程序，再稍加改动。-C8051F020 based on the basic procedures, and on this basis can make a lot of you want to do, as long as you understand the program, and then modified.

自己写的ATmega16单片机驱动1602液晶的头文件，本人已测试通过，不错！-himself wrote the ATmega16 LCD Driver 1602 for the first document, I have been tested, yes!

本程序有一定的参考价值，内含电路图及程序，有利于单片机开发-This procedure has certain reference value, including circuit diagrams and procedures, in favor of single-chip development

这是一个波形选择菜单，通过开发板上的按键，选择波形，幅度，频率的等各参数，然后发送给下位机。让其产生需要的波形。-This is a waveform selection menu, through the development of on-board buttons, select the waveform, amplitude, frequency and other parameters, and then sent to the next bit plane. The need to generate the waveform.