介绍一些原始的手臂代码，并在美国下分享。

ARM单单片机应用程序,将TS流转换为PSI的源程序,了解TS流的结构-This is a application program which work on ARM s MCU system. This program can translate the transport stream to PSI struct. With this program, you can know well about the TS struct.

arm中的中断向量表动态配置 中断向量表动态配置-arm of disruption to scale disruption to the dynamic allocation Scale Dynamic Configuration

周立功大侠编的一个学习arm嵌入式基础知识的好ppt,对初学者很有帮助-Week Ligong heroes made a study arm of a good basic knowledge of embedded ppt, very helpful for beginners

240128液晶的驱动程序 主控制器为ATMEGA16 开发环境为ICCAVR 可以参考-240128 liquid crystal host controller driver for the ATmega16 development environment for ICCAVR can refer to

打表格和画圆,且可以用Sleep()查看变化,是计算机图形学的一个上机实验-fighting forms and Circle, which can be used Sleep () View change is a computer graphics on the machine experiment

FREESCALE 16位单片机片MC9S12DG128的EEPROM读写操作程序,支持字节读写,字读写,长字读写,由产品验证,放心使用-SCM MC9S12DG128 writable EEPROM operational support byte read and write, read and write words, long words literacy, product certification and quality assurance use

用C51编写的51读写U盘的源程序,调试通过-with C51 prepared by the 51 U-writable disc source, through debugging

通过PC并口模拟I2C信号，编写sharp stV0288 芯片驱动，在VC++环境下编译通过。-PC parallel port through I2C signal simulation, prepared sharp stV0288 chip-driven, the VC environment compile.

ARM嵌入式系统 LPC22xx UART0通讯实验－中断方式代码-ARM Embedded System LPC22xx UART0 communication experiment- interrupt code

以lpc2119芯片为核心，通过AD端口读取电压值，经双CAN将值传送至CAN-USB转换器后传至上位机-To lpc2119 chip as the core, the port reads the voltage value through the AD, after the value of dual-CAN will be sent to the CAN-USB converter spread after the host computer