这是一个代uc/os和ucgui集成的44b0开发源码，已经通过FS44b0 v1.0测试通过的触摸屏程序，欢迎使用...

说明：  μC/OS-II and ARM Processors (For ARM7 or ARM9) (For ARM and Thumb Mode) Application Note,里边有很多源码和例子，非常好！(μC/OS-II and ARM Processors (For ARM7 or ARM9) (For ARM and Thumb Mode) Application Note, inside there are many source code and examples, very good!)

1.板上的8 个按键分别分别代表数字1-8，按下一个按键将结果通过串口发送到PC机上显示； 2.使用两个定时器模块，分别定时为1ms 和100ms 产生中断，使用它们分别 产生1s的定时时间，将时间分别显示到数码管上； 3.外接PS/2小键盘，将按键的值通过串口显示到PC机上。(A panel of eight key representing the number 1-8 press a key the results sent through the serial port on a PC display (2) use two timer modules, respectively, of 1ms and 100ms timer generates an interrupt, use them, respectively, Produce the timing of the 1s, the time display to the digital control External PS/2 keyboard, the key value of displayed through the serial port to a PC.)

UCOS/2对MSP430的嵌入式代码-UCOS/2 on the MSP430 embedded code

这是本人调用small rtos51的函数来仿真写的基本代码-This is a small rtos51 I call a function to write the basic code simulation

基于s3c2410 的LCD应用，文本显示图形显示等。(based on s3c2410 )

整理非常好,学习嵌入式操作系统的可以看看!有价值!可以学到许多满经典的设计方法! -Finishing a very good study of the embedded operating system can look at! Valuable! Can learn a lot over the classical design method!

这是帮助大家理解UC/GUI系统中关于窗口剪切原理的好东东，在他的帮助下，可以很容易的弄清楚GUI系统的内核思想。-This is to help everyone understand UC/GUI window system on the principle of good shear Wanton, in his help, you can easily find out the GUI system kernel thinking.

UCGUI3.32版本的使用手册，注意了，不是网上常见的32404版本，要的快下：）-UCGUI3.32 version of the user manual, attention is not on-line version of 32,404 common to the quick :)

用于8051的ucos

主要利用uCOS操作系统加GUS界面做的一个野火的单片机的系统应用界面。(Mainly use a uCOS operating system with GUS interface for a wildfire MCU system application interface.)