基于达芬奇芯片DM6437的图像空域低通滤波器

用DSP2407编写的BLDC闭环程序，针对特殊电机，程序调试好用-Written in closed-loop BLDC with DSP2407 procedures, for specific motor, easy to use program debugging

指纹识别C语言代码，对识别的开发学习很有帮助。-Fingerprint identification C language code, to identify the development of useful learning.

硬件要求：基于合纵达的SEED-VPM642的示例。软件要求：CCS2.2以上版本。对于想用DSP/BIOS开发的同道中人来说是很好的学习实例。-Hardware Requirements: Based on the combined longitudinal Tatsu SEED-VPM642 of the sample. Software Requirements: CCS2.2 above. For want to use DSP/BIOS development for the fellow human is a very good learning examples.

利用仿真器实现FLASH的在线烧写程序，适用于TI的C54X系列DSP-use simulator to achieve FLASH online burning procedures applicable to TI C54X DSP Series

主要测试USB 连接并通过USB 接口控制SEED-DEC6713 上各种资源进行工作。由CY7C68001 兼容USB1.1 与USB2.0 标准，所以在一般的计算机上均能 进行USB 的调试。-USB to connect the main test and control through the USB interface on a variety of SEED-DEC6713 job resources. By USB1.1 and USB2.0 compatible CY7C68001 standards, so in general can be carried out on the computer" s USB debugging.

DSP 的全套资料，很辛苦收集来的哦，对初学者有很大的帮助-A complete set of DSP data collected is very hard Oh, to be very helpful to beginners

MAX125和80c196接口程序１４位Ａ／Ｄ－ＭＡＸ１２５与８０１８６及ＤＭＡ控制器的接口应用 -MAX125 and Graphics Interface Program 14 bit ADC-MAX125 with 80186 and DMA Controller Interface Application

c语言编制的存储器dsp实验测试程序，可在ccs下运行-memory dsp experimental procedure can run in ccs

基于DSP的数据采集与处理系统的设计，对硬件开发者有较高的参考价值。-DSP-based data acquisition and processing system design, hardware developers have a high reference value.

这是一个基于TI的DSP的ADPCM的源代码,经过测试.-This is a based on TI"s DSP ADPCM source code tested.