此为按键部分的,读取按键值是否有按键判断部分函数

CAN的调试程序。CAN的初始化重要包括下面几个方面。RXB0SIDH，RXB0SIDL，RXB0MIDH，RXB0MIDL。这是接收过滤器。TXB0SIDH，TXB0SIDL，TXB0DLC，这是发送标志位。还有波特率寄存器。操作模式为 正常模式。-CAN debugging procedures. CAN initialization important aspects include the following. RXB0SIDH, RXB0SIDL, RXB0MIDH, RXB0MIDL. This is the receiver filters. TXB0SIDH, TXB0SIDL, TXB0DLC, it is sending signs spaces. There baud rate register. The normal mode of operation for the model.

关于收音功能代码,并且显示在OSD和VFD上-Radio feature about the code, and show up in the OSD and VFD

Discription: This multi-master driver provides the software interface to the I2C Bus hardware of the M3062x series of MitsubishiMCU.

本程序又是一个单片机的简单例程，含电路图及C程序，可参考-This procedure is a simple and routine single-chip, including circuit diagrams and C procedures, can be found! !

arm lpc2132 driver for GPIO_LEDs8_IOPIN

：介绍一种无人值守的停车场管理系统的设计。该系统前端主要由GsM 短信模块TC35i和AVR 单片机At― megal6组成，安装在停车场的每个进出口，通过接收车主的手机短信控制进出口道闸的开启并由短信扣取停车费用，各进出 口电路都与监控中心计算机连接。-: A unmanned car park management system design. The system front-end GsM messages by AVR module TC35i and At-megal6 composed of single-chip installed in the parking lot of each import or export through SMS to receive the owner to control the import and export of道闸open parking fees deducted by SMS , the import and export of circuits are connected with the monitoring center computer.

基于mega48单片机的步进电机分割程序mega48

很完整的门禁系统原码，希望能帮助大家更好的学习学习一下

msp430单片机-MCU Controller

凌阳公司的光敏电阻传感器源代码，代码中注有非常详细的代码功能注释。-Sunplus