SCM notes

用8051驱动240*128液晶的C51程序，控制器为T6963，由于代码比较大，试验时请用52 本程序移植性较好，已成功移植到MSP430上-8051 with 240* 128 LCD drive the C51 procedure, the controller for the T6963, as a result of relatively large code, test when you use 52 transplant procedures better, have been successfully transplanted into MSP430 on

为8个数码管有五种模式的闪烁方式 可以通过按键控制的，-to eight digital possession of five patterns of flashing mode can be controlled by buttons,

基于51系列的电子锁设计方案，包含程序，pdf文件-Based on the 51 series of electronic lock design options, including procedures, pdf file

zlg 的easyarm easyarm-ZLG

设计程序使一个LED发光管以0.6秒为周期闪烁，即发光管每0.3秒点亮或熄灭一次。 分析题目要求，主要涉及两方面的操作，即控制LED发光管的亮灭以及定时0.3秒。对于LED发光管，只用一个IO就可以控制了（例如使用IOA0）；而对于0.3秒定时，我们可以利用TimerA定时器轻易地实现。-The design process of a LED to LED blinking 0.6 seconds for the cycle, that is, every 0.3 seconds LED lit or extinguished once. Analysis of the subject requirements, mainly related to two aspects of the operation, that is, control LED LED light out as well as the timing of 0.3 seconds. The LED light-emitting tube, only one can control the IO (such as the use of IOA0) and for 0.3 seconds from time to time, we can use to easily achieve TimerA timer.

nrf905无线开发 调试原代码 和51通信-Wireless Developer nrf905 debug the original code and 51 communications

友善臂开发板上使用的S3C2410，2.6内核的LCD驱动，源码包以及移植方法。-A friendly arm on the board used in the development of S3C2410, 2.6 kernel LCD driver, source packages as well as the method of transplant.

PIC单片机控制CH452的数码管显示程序-PIC SCM CH452 digital tube display program

C51 ATAPI-CDROM 驱动程序-C51 ATAPI-CDROM driver

基于 51 的倒车雷达-turned 51 on the radar