仪表运行，带有lcd显示和按键控制，希望能给大家学习参考

QG8_demo学习板开发板例程 ｉ２ｃ的例程，辛苦找来。 经过验证是正确的。-Board development board QG8_demo learning routines i2c routine, it is tough to get a large. Verified to be correct.

自己动手，进入单片机的大门-yourself into the door MCU

对充电过程进行更精确的监控，以缩短充电时间、达到最大的电池容量，并防止电池损坏-Charging process of a more precise control, so as to shorten the charging time to reach the largest battery capacity, and to prevent battery damage

单片机控制的电动自行车驱动系统部分程序 单片机控制的电动自行车驱动系统 单片机型号为16F876 采用块定义的方法定义单片机内部寄存器-MCU control of the drive system for electric bicycle parts of the SCM control drive system for electric bicycle for the 16F876 microcontroller models using block definition of the definition of internal registers MCU

2008北京奥运会的倒计时牌的课程设计,3块数码管分别显示年月,时间,剩下的天数-The countdown to the 2008 Beijing Olympic Games licensing curriculum design, digital tube 3, respectively, show the date, time, number of days remaining

串行DA MAX517测试程序,测试通过，用示波器观察输出3.88V电压。

基于单片机的交流伺服电机运动控制系统研究与开发-Based on single-chip AC servo motor motion control system research and development

用ansi c 实现针对时钟芯片HT1380的驱动程序，以及实现电子时钟的源码-with ansi c achieve against the clock chip HT1380 driver, and the realization of the electronic clock source

PIC18单片机与LCD1602的C语言程序，主要LCD几个控制管脚的定义。-PIC18 MCU and LCD1602 the C language program, the main LCD control pins of several definitions.

LCD12864,T6963控制器的C源程序-LCD12864, T6963 controller C source