PHS通信测试程序

本文档详细介绍了在WINDOWS下用VC6.0编译ORTP的方法,还有要用到的4个头文件-this document described in detail under Windows with VC6.0 compiler ORTP way still have to use the four header file

C#制作的即使通讯程序源代码-C# produced by the messaging program source code

Very Low Frequency (VLF) spectrograms show sometimes sets of lines called MLR (Magnetospheric Line Radiation) with frequency spacing close to 50 or 60 Hz. It is very tempting to attribute these MLR to Power Line Harmonic Radiation (PLHR). PLHR are the ELF and VLF waves radiated by electric power systems at the harmonic frequencies of 50 or 60 Hz. Here we show for the first time large scale MLR observed simultaneously on ground and on board a low altitude satellite which is flying over the same zone.

串口通讯PB原程序-PB original serial communication procedures

这个是串口驱动程序开发包-Serial Driver Development Kit

gprs短信的收发短信的源码, 已验证 可以使用

linetd是一个压缩TCP高级服务器。所有的设置值都受控于命令行。与tcp服务器或sinetd类似。-linetd compression is a senior TCP server. All settings are controlled value on the command line. With sinetd tcp servers or similar.

0. Install the rp-pppoe-software -------------------------------- You should have already done this by the time you re reading this. If not, go back and read README. 1. Set up your Ethernet hardware -------------------------------- First, make sure the Ethernet card you intend to use with the modem is visible to the Linux kernel. Just how to do this is beyond the scope of this document. However, if the card is the only Ethernet card in the system, executing: ifconfig eth0 should display something like this: eth0 Link encap:Ethernet HWaddr 00:60:67:62:31:D4 plust some more lines. Your HWaddr will be different. As long as you see the HWaddr line, your card should be working. DO NOT assign an IP address to the Ethernet card. DO NOT configure the card to come up at boot time.-0. Install the rp- PPPOE-software-------------------------------- You should have al ready done this by the time you re reading this. I f not, go back and rea

串口通信控件mcsomm的例程，该程序用于与DSP板通信，DSP板通过串口传输一副位图到PC端-Serial communication control mcsomm the routines, the program used for communication with the DSP board, DSP board through a serial transmission to the PC client bitmap

中文RFC文件，无需翻译，对学习很有帮助！