单径瑞利信道中的两发一收STBC：Simulink进行仿真，测量BPSK调制时的误码率性能。画出比特信噪比与信道估计均方误差的关系曲线，画出比特信噪比与误码率的...

用于WLAN 802.11a的OFDM发射机的数字调制16QAM-For WLAN 802.11a transmitter of the OFDM digital modulation 16QAM

MIMO信道仿真源程序和说明书，其中有详细的说明文字，有一定参考价值-MIMO channel simulation source code and manuals, including detailed description of the text has a certain reference value

KEIL C键盘扫描, KEIL C键盘扫描-KEIL C keyboard scanning, KEIL C keyboard scanning

IPV6deshiyongfa

Matlab simulate AMP.It covers that the source code and how to compile it-Matlab simulate AMP.It covers that the sou rce code and how to compile it

北京邮电大学的初级通信导0论PPT，对于初学者有帮助。-Beijing University of Posts and Telecommunications in the initial communication 0 Introduction On PPT, help for beginners.

高斯脉冲的频谱分析。近似计算并画出高斯脉冲的前15阶导函数的ESD。-Gaussian pulse spectrum analysis. Approximate Gaussian pulse is calculated and drawn 15 of the first derivative function of ESD.

用于的dsp builder的matlab实现算法，产生可编程的sin或cos波形，可以通过它作为ddc的dds-For the dsp builder of matlab algorithm, resulting in programmable waveform sin or cos can be as ddc the dds

七号信令讲义.doc 和 MG003003 SCCP信令原理ISSUE1.1.doc-Signaling lectures on the 7th. Doc and MG003003 SCCP signaling principle ISSUE1.1.doc

三点式振荡器是指LC回路的三个端点与晶体管的三个电极分别连接而成的电路，如图4-1（a）所示。图中三个电抗元件X1、X2、X3构成了决定振荡频率的并联谐振回路，同时也构成了正反馈所需的反馈网络。从相位条件看，要构成振荡器，必须满足： (1)极相连的两个电抗X1、X2性质相同。 (2)X1与X2、X3的电抗性质相反。-three-point refers to LC oscillator circuit with three transistors endpoint of three electrodes were connected with the circuit, Figure 4-1 (a) below. Figure 3 reactor components X1, X2, X3 decision constitutes a frequency of the oscillation parallel resonant circuit, but also constitutes a positive feedback for the feedback network. From Phase conditions, to constitute an oscillator, to be met : (a) very connected to the two reactor X1, X2 the same nature. (2) X1 and X2, X3 nature of the resistance-- contrary.