dsPIC完成高

51+sl811读写U盘的源程序＋原理图。想用51完成U盘读写的网友可参考参考。-51 sl811 reader of the source disk U+ diagram. With 51 to complete U-reader may refer to the website reference.

基于单片机的推挽型逆变器控制系统设计及其程序设计 SA838初始化及控制子程序 ADC0809的控制及数据处理子程序 数据处理及电压显示子程序-MCU-based push-pull type inverter control system design and programming SA838 Subroutine to initialize and control the ADC0809 data processing control and data-processing subroutine and voltage display subroutine

本程序是一个人机接口程序，包含18B20,AD,DA,LCD，等各种源程序-This procedure is a man-machine interface program, including 18B20, AD, DA, LCD, and other source

利用STC单片机实现软件模拟全双工串口的程序，只用一个定时器，消耗系统资源很少。-using SCM software simulation of the full-duplex serial procedures, only a timer, depletion of scarce resources system.

C51 Timer 0 的使用 Timer_0_mode_0_counter_gate_soft-C51 Timer 0 use Timer_0_mode_0_counter_gate_soft

本程序采用AVR单片机实现对温度传感器DS18B20的控制-This procedure used to realize single-chip AVR temperature sensor control DS18B20

单片机下的ADC0809驱动程序-the ADC0809 SCM Driver

本人所做项目中用51系列单片机(STC89C58RD)对OCMJ8*15B液晶屏进行数据写操作时所写的配套源代码,可以直接在keil7.0以上的版本中嵌入开发！应该说本程序有很高的实用价值（本人开发的产品已应用于实际工业控制中）-I conducted a series of 51 projects using SCM (STC89C58RD)* 15 OCMJ8 B LCD screen for data write operation written by supporting source code, keil7.0 directly on the above versions embedded development! It should be said that this program has high practical value (I development of the product has been used in practical industrial control)

液晶19264驱动程序。显示一串字符。用AT8515L控制，经过调试成功-19,264 LCD driver. Showed a bunch of characters. With AT8515L control, after successful testing

freescale MCF5485EVB开发板上中断操作示例，利用一个timer产生中断，另外3个timer作为GPIO，使3g个LED每隔1秒钟轮换亮一次。-freescale MCF5485EVB interrupt the operational example of the development board, using a timer generate an interrupt, another three timer as a GPIO, so 3g a LED light at one-second rotation time.