汇编语言的简单汇编工具，包含 CREF LIB LINK MASM

时钟中断历程 可以下下来参考一下 很不错的程序 适合于汇编初学者参考-Process can break down the clock, under the procedures refer to very good reference for beginners compilation

IO 驱动 LCD , *** *** *** *** FILE NAME: IO_LCD MCU: HT46R22 MASK OPTION: WAKE-UP: PA6,PA7 PULL-HIGH: PA,PB,PC IIC: DISABLE PFD: DISABLE PWM: DISABLE WDT: ENABLE CLRWDT: ONE WDT CLOCK SOURCE: T1 WDT TIME OUT SELECT: WDT CLOCK SOURCE/32768 LVR: DISABLE OSC: CRYSTAL SYSVOLT: 3.0V SYSFRAG: 4000KHZ AUTHOR: RADOME HISTORY: 2005.08.

Abstract A new intelligent milometer base on a microcontroller can count the sum. By taking full use of the processor 89s51 and E² PROM (AT24C02) and sensor of magnetism, it can count the sum of fully distance and the course of development.

学习汇编语言编制的程序，非常参考价值，我认为汇编比较难。-Learning assembly language produced by the procedure, very useful, I think more difficult to compile.

经典的迷宫算法，这是一个迷宫算法很好的例子，不懂的人可以下来-classic maze algorithm, which is a maze algorithm good example, but not the people can look down

这是一个关于嵌入试开发的简单例子，大家可以参考一下，为以后的学习打基础-This is a test of embedded development simple example, we can take a look to the future to build up the foundation of learning

介绍两类同步方法都是采用滑动相关寻找峰值的办法，区别在于使用的相关器模板和先验信息。每种方法在具体实现上又可分为：串行搜索和并行搜索-Introduce two types of synchronization methods are used to find the peak sliding correlation approach, the difference lies in the use of the correlator template and a priori information. Each method in the concrete realization can be divided into: serial search and parallel search

利用PC机的硬件定时8253, 编制秒表延时(0~9秒)程序.要求: 按任意键,开始计时, 在屏幕上以1秒间隔从0到9显示 按ESC键,计时停止.-use of PC hardware-timed 8253, the establishment of a stopwatch Delay (0 ~ 9 seconds) program. Requirements : by the arbitrary button, the timer on screen to a second interval from 0 to 9 shows by the ESC key, a time to stop.

以MPS430F149为硬件平台，利用I/O口模拟I2C总线协议，对日精的时钟芯片S35390A_C做了初始化子程序、读时钟子程序、写时间子程序、脉冲为1赫兹输出子程序。-To MPS430F149 for the hardware platform, the use of I/O port simulation I2C bus protocol on-chip clock nissei S35390A_C done initialization subroutine, read subroutine clock, the time to write subroutines, pulse for 1 Hz output subroutine.

这是键盘接收处理子程序。可以当作通用程序使用-receiving and processing subroutine. Can be used as a general program