直流电机调速模块采用模拟出租车的速度，通过模数转换为S。

在Diameter3588协议的基础上开发的软件，在此基础上可以进一步扩展功能-Diameter3588 agreement in the basis of software developed on this basis function can be further expanded

CRC16 源程序，MODBUS的校验程序-CRC16 source, MODBUS calibration procedures

机械产品控制器，控制了变频器，并且接入了很多开关量信号-mechanical products controller, control of the converter, and a lot of access off Signal

本程序运行于C8051F330，功能为接收遥控器发出的红外信号，然后等待上位机通过I2C总线来读取。IR数据接收完毕后，不再采集新的IR数据，一直等待上位机将数据取走后才开始准备接收新的IR数据-this program running on the C8051F330, functional remote control device to receive the infrared signal, Then wait for the PC through the I2C bus to read. IR data receiving end, not the acquisition of new IR data have been waiting for the PC will be removed after data began preparing to receive the new IR data

关于msp430F21xx各个模块的代码，完全可以放心大胆的用-About msp430F21xx each module code, can rest assured that with the bold

samsung arm2440开发板 数模转换测试程序，程序开发平台为qt平台开发环境为linux系统-samsung arm2440 development board digital-to-analog conversion test procedures, procedures for qt platform development platform development environment for linux system

两个控制595的小程序。保证大家看后可以非常容易的学会使用它以及其他串进并出等器件-595 small two control procedures. To ensure that we can very easily look at the Institute of string to use it, as well as other devices, such as into and out of

单片机课程设计程序，利用单片机模块实现键盘扫描输入输出显示-SCM curriculum design process, the use of MCU module for the keyboard scan input and output display

条码读入CPU 1. 与条码读入器的通讯 1.1 采用标准的UART通讯协议，波特率为9600，没有校验位，一个停止位。 1.2 通讯的过程是单工的，数据流总是从条码读入器到CPU。 1.3 正常的数据传送总是以一个换行符开始，六个数字，以一个回车符结束。 -51

继续上传：单片机89C51，LCD12864密码锁。-Continue to upload: Singlechip 89C51, LCD12864 locks.