DS18b20d the C51 process a number of functions including:// Delay subprogram// r...

有关OSD开发和ADI公司的几款ADC软件控制-OSD-related development and ADI

一个关于液晶的单片机例程，和液晶的资料，很有启发意义的。做液晶时可供参考。-an LCD on the MCU routines, and LCD information, the significance is very enlightening. So when the LCD for reference.

无功补偿仪是用于补充电网无功功率#提高功 率因数!保证供电系统安全运行#减少电能损耗#节 约电能的设备$ 在以单片机 "#$ &’($ 为 $)* 的 无功补偿仪系统中# 我们选用了 +,- ."’/-. 液晶 显示器来显示各相电压 电流 无功功率 有功功率 及波形畸变率等参数$ 本文主要讨论 +,- ."’/-. 的电路连接与软件控制方法# 特别对 +,- ."’/-. 应用的独特之处做了详尽的分析并给出了实例-wewq

用单片机配置FPGA，英文，不用说了吧，呵呵，快下吧-MCU FPGA configuration, English, needless to say, all right, what are you fast

DS1302实时实钟avr单片机控制程序-DS1302 real-time clock control procedures avr Singlechip

a good program for battery charge,only for reference

PIC18F4550_USB开发原代码，可以给需要用单片机开发USB通信使用参考-PIC18F4550_USB development of the original code, can require the development of USB communication using single-chip reference

MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to

This version of the code is compatible only with the AT89C2051 due to the location of the data buffer and stack in RAM. The code may be modified to work with the AT89C1051 by relocating or resizing the buffer and stack to fit into the smaller amount of RAM available in the AT89C1051.

自己写的CH452的驱动，用keil C51写的-himself wrote the CH452 drive with the Keil C51 write