STC89C55+STA013+CH375设计读U盘（已经通过）/硬盘（还没调试，也放上来）的MP3播放器，支持歌曲的选择，歌词的显示等等的完整源代码（KEIL...

ARM7+D12开发U盘的资料(中pdf)_老古开发网下载特区-ARM7+ D12 Development U disk information (in pdf) _ nerd Development Network to download the SAR

USB设备端固件程序,枚举部分是全部程序的基础和重心,只有主机对设备枚举成功后,主机才能和设备进行正常的通信 USB的枚举过程分为4个状态. 1.接入态 v主机检测到USB设备插上,击活端口,并发送复位命令(保持10ms) 2.默认态 v主机使用默认地址读取设备描述符 (GET_DESCRIPTOR) v主机分配给设备一个总在线的唯一地址 (SET_ADDRESS) 3.地址态 v主机从新的地址获取设备描述符(GET_DESCRIPTOR) v主机获取所有设备的配置描述符(GET_DESCRIPTOR) 4.配置态 v主机设置描述符(设备,配置) (SET_CONFIGURATION) v主机读取配置状态(可选) (GET_CONFIGURATION) v主机读取接口状态(可选) (GET_INTERFACE) -USB device-side firmware, enumerate all part of the foundation and focus of the procedure, only the host of equipment after the successful enumeration, the host and equipment in order to engage in normal communication USB enumeration process is divided into four status. 1. Access state v host detected USB devices plug in, hit live ports, and send the reset command (to maintain 10ms) 2. default state v Use the default address of the host to read device descriptor (GET_DESCRIPTOR) v host assigned to the equipment of a total online only Address (SET_ADDRESS) 3. A

This USB 3.0 Specification pdf. -This is USB 3.0 Specification pdf.

波形发生器bulktransferInf-waveform generator bulktransferInf

usb audio 2.0 connection-usb audio 2.0 connection

USB主机端的c语言代码，控制USB的主控器-USB host the c-language code, the master control USB

usb HID类设备通讯源程序-USB HID source category communications equipment

D12测试用户程序

isp1160_isa_evel_codeUSB主机软件，可驱动打印机，音频设备，鼠标? size=80>

USB2.0规范与EZ-USB-FX2高速外设控制器-USB Speci fication 2 .0 and EZ- USB FX2 High- Speed USB Peripheral Controller