这是示意图（ORCAD）和PCB（PowerPCB）文件，es6461数字面板等。

根据云南航天提供的平面图及应用要求，云南航天网络系统具成必需达到以下要求： 1．实现办公信息管理、局部办公本身办公自动化 作为现代化的办公信息管理，大楼内部实现办公自动化及其他管理关键性应用，必须依靠先进的计算机网络技术，综合布线系统是一套基本的布线网络，为计算机网络的应用提供必要的基础。 2．实现油库域网与外部网络的连接 云南航天局域网是以综合布线系统为传输介质的。要实现云南航天局域网与外部网络的连接，也必须通过综合布线系统。-Yunnan space under the floor plan and application requirements, Yunnan space into a network system is necessary to achieve the following requirements : 1. Achieving information management office, local office automation office itself as a modern office information management, internal realization of the building and other office automation management of critical applications, we must rely on advanced computer network technology, integrated wiring system is the basic set of network cabling for computer networks should be used to provide the necessary infrastructure. 2. To achieve the depot area network and external network connections Yunnan space is an integrated LAN cabling systems for the transmission medium. To achieve Yunnan with the outside space LAN network connectio

线性分组码中标准阵列的进一步改进 很好的论文 可以了解线性分组码的标准阵列解码过程-Linear block codes in the standard array of further improvement of the thesis can be a very good understanding of linear block codes of the standard array decoding process

带余弦预滤波和补偿滤波的抽取滤波器　设计方案-Pre-filtering with a cosine decimation filter and compensation filter design

条件接收系统和DVB 解码器其他应用的 Common Interface 规范-Conditional Access System and other DVB decoder application of the Common Interface standard

本文件通过一篇科技论文,来介绍神经网络的简介应用，过程以及模型的修正。-This document is a science and technology through the papers, to introduce a brief introduction of neural network applications, process and model amendments.

针对某些嵌入式系统中处理数据量大和速度要求高的特点, 在剖析了uCOS - Ⅱ内核工作原理的基础上, 提出一种应用于uCOS - Ⅱ中的大容量内存文件系统的实现方案1 该方案通过在内存中建立文件系统, 将临时数据有效组织于内存中, 既提高访问速度又节省外存空间-against certain embedded systems handle large data volume and speed of high-features in the analysis for uCOS-II core principle on the basis of An application for uCOS-II, a large memory capacity of the file system to achieve a program of the program in 1988 through the construction documents, data will be temporarily effective organization in memory, not only increase the rate of savings Disk Space

1．任意选取一个灰度图像和彩色图像，对算法中若干关键语句中的参数进行调整，得出不同的实验结果，并对这些结果进行分析。 2．根据自己所学知识，提出自己的轮廓线提取方法，与简单阈值法进行比较分析。 3．练习matlab自带算子的检测结果。 -1. Arbitrarily select a gray-scale images and color images, several key statements on the algorithm to adjust the parameters, results in different experimental results, and these results were analyzed. 2. Learned based on their knowledge, put forward its own contour extraction method, with a simple threshold method for comparative analysis. 3. Matlab built-operator practice test results.

信号灯受一个启动开关控制，当启动开关接通时，系统开始正常工作，且先南北红灯亮，东西绿灯亮；当启动开关断开时，所有信号灯熄灭；南北绿灯和东西绿灯不能同时亮，如果同时亮则应报警后关闭信号灯系统。-To start signal by a switch control, when the start switch connected to the system started to work, and the first north-south red light, green things when the start switch off all lights extinguished north-south and east-west green light green light can not be at the same time, if At the same time, bright lights should be shut down after alarm system.

1.模拟并发进程共享的临界资源m1、m2，它联系着两个信号量sem1、sem2. 2.模拟并发进程的运行现场：通用寄存器i,程序计数器addr. 3.模拟三个并发进程.-1. Simulation of the process of sharing with the critical resources m1 and m2, it is tied to the volume of two signals sem1, sem2. 2. Simulation of the process of running with the scene : Definitive register i, procedures counter addr. 3. Three concurrent simulation process.

是一个开发软件,利用pb开发的一个学生管理系统-Development is a software development using pb of a student management system